BioTillion LLC BM02 User Manual
Quick Setup Guide - BoxMapper II
①
Connect the BoxMapper II to the Ethernet using the port on the back of the BoxMapper II.
②
Connect the power cord to the BoxMapper II. After about 30 seconds both LEDs will be solid green. This
means that the BoxMapper II has booted and is waiting for an IP address from the router. After another
20 seconds the LEDs will both flash green - this can take more or less time depending on your router.
means that the BoxMapper II has booted and is waiting for an IP address from the router. After another
20 seconds the LEDs will both flash green - this can take more or less time depending on your router.
③
When both LEDs flash green the BoxMapper II is ready for use.
④
Open a web browser and connect to the BoxMapper II by entering the URL printed on the label on the
bottom of the unit. You should see a screen similar to this (note that this screenshot was taken on a mac
but the webpage is identical on a PC):
bottom of the unit. You should see a screen similar to this (note that this screenshot was taken on a mac
but the webpage is identical on a PC):
⑤
Place a box on the BoxMapper and press
Scan. After a few seconds the box contents will appear on the
webpage. The last 4 digits of the vial IDs are shown in the vial locations due to space constraints, but the
full vial EPC can be seen by clicking on the vial.
full vial EPC can be seen by clicking on the vial.
page of
1
4
BioTillion © 2017