E&C Technologies Co. Ltd EC200 User Manual
To Charge the Battery
Battery must be fully charged before use the first time!
a.Connect the Charge cable to charging socket on headset
b.Plug the charger to a wall(A/C)outlet
c.Indicator light shows red.when fully charged the red light turn off
d.Or,slide the headset into the Charger Cradle,indicator light shows
red,turns off when fully charged
e.Remove headset from Charger Cradle
To charge the Charger Cradle
Battery must be fully charged before use the first time!
a.Connect the charger cable to charging socket on the cardle
b.Plug the charger to the wall(A/C)outlet
c.Indicator light shows red,turns off when fully charged
d.Disconnect charger from cradle and wall outlet
Uses the original factory standard the charger
To Switch the Headset Power on/off
a.To power on:press and hold answer/end key for about 3seconds until blue
b.To power off:press and hold for about 6 seconds ,goes off
To Pair the Headset with a Bluetooth Enabled Phone
a.Turn on headset, in standby mode
b.Set the phone to search for Bluetooth device
c.When phone finds headset,confirm by selecting the headset from list
d.Enter passcode 0000 when prompted by phone
e.Repeat steps if the pairing was unsuccessful only need to pair once
f.If pairing was successful,starts to flash blue,indicating in standby
mode and ready to make/receive calls
To Answer a Call
a.Press the answer key on your phone,or
b.Press the answer/end key on headset briefly
To end a Call
a.Press the key on your phone ,or
b.Press the answer/end key on headset briefly
To Reject a Call
a.Press the end key on your phone,or