Sanitag Technologies Corporation AT00123H User Manual
Setting Up Devices & RF Netwowk
1-4
THIS DOCUMENT IS THE PROPERTY OF SANITAG COMPANY. IT MAY NOT BE COPIED AND REPRODUCED WITHOUT WRITTEN PERMISSION OF SANITAG
COMPANY. COPYRIGHT NOTICES MAY NOT BE REMOVED
1.1. Device Definitions
1.1.1. Sanitag AC-001-LAN (Wireless Router)
THIS EQUIPMENT COMPLIES WITH THE FCC RF RADIATION EXPOSURE LIMITS
SET FORTH FOR AN UNCONTROLLED ENVIRONMENT. THIS EQUIPMENT SHOULD
BE INSTALLED AND OPERATED WITH A MINIMUM DISTANCE OF 20CM BETWEEN
THE RADIATOR AND ANY PART OF YOUR BODY.
SET FORTH FOR AN UNCONTROLLED ENVIRONMENT. THIS EQUIPMENT SHOULD
BE INSTALLED AND OPERATED WITH A MINIMUM DISTANCE OF 20CM BETWEEN
THE RADIATOR AND ANY PART OF YOUR BODY.
Router is hierarchically the top-most Node of 802.15.4 RF Network . It forms/manages RF
Network, collects all RF Network data and behaves as a gateway from RF Network to
upper media. There are two type of Router:
Network, collects all RF Network data and behaves as a gateway from RF Network to
upper media. There are two type of Router:
Router with Ethernet Interface: Redirects RF network traffic to a prederfined “IP:Port”
over ethernet via TCP/IP protocol.
Router with USB Virtual Com Port Interface: Redirects RF network traffic to Serial
Port.
Router device has blue leds on itself.
If leds blink, it means that the router device tries to form Rf network.
If leds lighten constantly, it means that the router device forms Rf Network
succesfully.
Sanitag AC-001-LAN device has RF propagation that 2.5 dBm output power level and it
has 2,4 GHz uFl tranmitter antenna which is has 2dBi gain.
Also, AC-00-H device has UWB module* that has 3.1 ~ 8 GHz monopole antenna. We
operation at 4.4GHz due to special reason. UWB Module output power is fully adjustable
from 0 dBm to 15.5 dBm via firmware.
*NOTE FOR UWB “THİS EQUİPMENT MAY ONLY BE OPERATED İNDOORS.
OPERATİON OUTDOORS İS İN VİOLATİON OF 47 U.S.C. 301 AND COULD SUBJECT
THE OPERATOR TO SERİOUS LEGAL PENALTİES.”
The antenna that using on Sanitag AC-001-LAN is wire antenna which is fixed on PCB,
That's why İt cannot change reorient and relocate.The device's antenna type is
omnidirectional. Therefore, the Sanitag AC-001-LAN can take signal every direction. If
Sanitag AC-001-LAN obstructs by obstacle of in Table 1. The device’s RF signal will
decrease as stated in Table 1.
That's why İt cannot change reorient and relocate.The device's antenna type is
omnidirectional. Therefore, the Sanitag AC-001-LAN can take signal every direction. If
Sanitag AC-001-LAN obstructs by obstacle of in Table 1. The device’s RF signal will
decrease as stated in Table 1.
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS
SUBJECT TO THE FOLLOWING TWO CONDITIONS.
(1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS
DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING
INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.
Warning: Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate this equipment.