SHENZHEN FATSHARK ELECTRONIC CO. LTD FSV2704 User Manual

To charge the quadcopter, plug the charger into a powered USB port and 
connect the battery to the white connector.  A red LED indicates the charger 
has power. During charging, the green LED flashes; once charging is complete, it 
stays illuminated.

To charge the Recon headset, plug the included micro USB cable into the port 
on the side of the goggles. The LED is green when charging and changes to red 
when the charge is complete.

LiPO BATTERY WARNINGS: 
•  Only charge the batteries with the included USB charger.
•  Lithium batteries can become a safety and fire hazard and must  

be handled properly

•  Only use chargers intended for LiPo batteries
•  Never attempt to charge a damaged LiPo battery
•  Never attempt to charge a hot LiPo battery
•  Never cut, puncture, bend or otherwise damage a LiPo battery
•  Never expose the battery to fire or other sources of heat
•  Never leave charging batteries unattended
•  Do not expose the batteries to water
•  Do not discharge the battery cells below 3.0 volts
•  Do not modify the batteries
•  Do not dispose of battries in the garbage; proper disposal required
• Risk of explosion if battery is replaced by an incorrect type.
• Dispose of used batteries according to the instructions.

All RC controls are proportional. Moving the control stick a 

small amount will result in a slow response. Moving the stick a large amount will 
result in a fast response.

 With the radio in your hands, move the flight mode switch in the top 

left corner to the top position (away from you) for Beginner mode. In this mode, 
the quadcopter will automatically level and flight controls will be eased. When 
the pitch and roll sticks are centered, the aircraft will maintain a level attitude. 
Moving the pitch and roll stick will cause the quadcopter to tilt in the desired 
direction. This mode is also called Angle mode because the control stick position 
dictates a bank angle.

 Move the flight mode switch to the middle position for Interme-

diate mode. When flying in this mode, the aircraft does what the pilot com-
mands with no automatic stabilization, however the maximum speed and rates 
will be reduced. This is also called Rate command or Acro mode.

 Move the flight mode switch to the lower position for Pro mode -- or Acro 

mode without limits.  In general, the quadcopter in this mode will hold an atti-
tude when the stick is released; when then stick is moved again the aircraft will 
continue to flip or roll as long as the stick is held. 

The 101 quadcopter flies without GPS stabilization; some drift during 

flight is normal. Always keep your fingers on the sticks to balance out the drift 
and maintain thrust.

Video frequencies for this product operate on 5.8GHz bands. The available 
frequencies are divided up into 2 bands with 8 channels on each. These bands 
also overlap and use the same frequency range so it’s not recommended to fly 

Only one video transmitter can occupy a channel at any given time. If more 
than one transmitter is transmitting on a frequency, if there is a user on an 
overlapping channel from another band or if there is outside interference, 
video reception can be disrupted. 

The battery in the headset is a standard 18650 2600mAh Li-Ion cell, and can 
be charged with the built-in charger by connecting a micro USB power supply 
to the headset. 

Slide the 5-way button left and right or forward and back for brightness  
and contrast adjustment.

Tap the 5-way button to scan for the strongest channel on your band.

Tap the channel buttons to manually change frequencies; hold them to  
change bands.

  

h

c

t

i

w

S

 

e

d

o

M

 

t

h

g

il

F
(switch in top posi-

tion for easy mode)

Motor Start/Stop Switch

Throttle/Yaw Control Stick

Pitch/Roll Control Stick

Battery  

Power Indicator

Power Button

USB Port

USB Charge Port

Power Switch

2600mAh  

18650 Li-Ion 

Battery

BOTTOM VIEW

Antenna  

Connector

5-Way Button

Channel Buttons

TOP VIEW