Mooredoll Inc. MD005 User Manual

Page of 4
FAQ
疑难排解
Warring
警告注意
Light instructions
灯光状态
Cannot perform pairing? Please check
   
Already downloaded “MOORE CARE” app and finished the certification.
   
Check the smart phone has connected to Wi-Fi.
    
Device can only support Wi-Fi with 2.4GHz (5GHz is unavailable).
   
Wi-Fi setting shall not be hidden mode, the SSID must be discoverable.
   
Check the blue light are flashing (Pairing mode).
   
Connected device numbers of Wi-Fi router shall be less than limitation.
   
Check the Wi-Fi SSID and Password.
   
Check the firewall settings, whether blocked some ports. (Such as 443).
   
Indication light shall be blue and flashing when pairing.
   
Do not pull or cut the wire. 
   
Please make sure you are in safe condition when inserting the plug.
   
Please do not use the incorrect adapter.
   
Please do not use chloride (ex: bleach) to wash the device.
   
Please stop to use the device when any issue happened 
   (Such as high temperature, abnormal noise, etc.)
   
Do not disassembly product by youeself. 
   
搬运和拆装时请勿拉拽电源线,以免发生短路或断线现象。
   
切勿使用潮湿的手插拔电源插头,会造成触电危险。
   
请勿使用不合适的电源插座。
   
请勿使用氯化物(如漂白剂等)、酸性的洗涤剂,请使用海绵清洗。
   
若产品发出异声和高温,请立即停止使用。
   
请勿自行拆卸产品内部硬体结构。
无法成功配对? 请确认以下项目
   
已下载“MOORE CARE”应用并完成手机注册。
   
家中需安装可连线的无线路由器。
   
无线路由器须为2.4GHz频段。
   
无线路由器不可为隐藏模式。
   
配对前,需确保无线路由器可以用手机搜索到,并将手机连接到此网络。
   
当无线路由器连接太多设备将可能配对失败。
   
配对时手机App应用上输入的无线路由器名称(SSID)以及密码须正确。
   
请检查防火墙设置,不可阻挡了常用端口 (如443)。
   
配对时摩豆宠拍恋水宝LED必须为蓝灯闪烁状态。
Software update
软件升级
Water refill and clean
换水清洗
产品无需断电,直接将储水桶拿至水槽,
使用海绵清洗后再放回主机即可。
* 请勿使用刷子刷储水桶。
* 装水建议参照水位线范围,不要低于或
  超过。
You could take the whole water bucket 
from device directly without power off, 
and use washing sponge to clean. 
* DO NOT use brush.
* Refill the water to the MAX line, don't   
  be higher than MAX line.
本产品会不定时执行自动升级以提供更好
更稳定的服务
当碰到软件升级时的灯光状态:
   蓝灯长亮(此时产品的水将停止流动)
   蓝灯闪烁
   蓝灯长亮
   升级成功蓝灯呼吸
* 软件升级时请不要关闭产品电源。
In order to make the device better, it will
perform reasonably probable software 
update automatically.
Indication light will be following behavior 
when software updating:
   Constant blue light 
   (The water is stopped flowing.)
   Flashing blue light
   Constant blue light
   Software is updated, and device goes 
   into standby mode.
*DO NOT turn off power when software 
  updating.
Normal 
Constant
Flashing
Breath
Blue light
Status
Starting
Pairing mode
Standby mode
Abnormal
Red light
Status
Live Streaming
Wi-Fi Disconnected
Insufficient water
Constant
Flashing
Breath
常态使用
蓝灯
状态
机器开始启动
产品进入配对状态
水量充足
产品处于待机状态
异常提醒
红灯
状态
摄像头使用中
网络不通
水量不足
长亮
闪烁
呼吸
长亮
闪烁
呼吸