DongGuan HuangJiang KaiYue Electronic Factory H-994RGB User Manual

 

4

3

Mounting with screws

 

Remove the mounting bracket (battery door) so that it can be 

used as a template for the screw holes. Rotate the battery 
cover counterclockwise and remove it. 

 

Drill two pilot holes in the location where you want to mount 

the puck light. Use the mounting bracket as a guide for the 
pilot holes.

 

Place the screws in pre-drilled holes. Don't over tighten.

 

Rotate the light clockwise on the mounting bracket.

2

Mounting with double-sided tape

NOTE: If you wish to mount the light with screws, proceed to Step 3.

 

Check the location of where you want to place the puck light. Make sure it is 

clean and that there is no debris or dust. 

 

Remove the protective film from one side of the double-sided tape (BB) and 

apply to the center of the mounting bracket (battery door). Peel off the 
remaining protective film and press the mounting bracket firmly to the intended 
surface for 5 seconds.

CAUTION: 

Be cautious of what surface the double-sided tape 

is attached to, as it may remove paint or damage the surface.

1

Replacing the batteries

 

If the LEDs appear to be dim, this is an indication that your 
batteries need to be replaced.

 

Rotate the battery cover counterclockwise and remove it.

 

Remove the old batteries and insert three new AAA batteries 
(C). Be sure to match the polarity as shown in the diagram in 
the battery compartment.

 

Check light operation to confirm that batteries are correctly 
installed.

 

Replace the battery cover and rotate it clockwise to lock it in 
place.

CAUTION: 

Do not mix battery types. Use only 

fresh batteries. Alkaline are recommended.