TCL Entertainment Solutions Limited TS5000 User Manual
- 7 -
1
2
4
3
Replace the Remote Control Battery
- The remote control requires a CR2025, 3V Lithium battery.
1. Push the tab on the side of the battery tray towards the tray.
2. Now slide the battery tray out of the remote control.
3. Remove the old battery. Place a new CR2025 battery into the battery tray
1. Push the tab on the side of the battery tray towards the tray.
2. Now slide the battery tray out of the remote control.
3. Remove the old battery. Place a new CR2025 battery into the battery tray
with the correct polarity (+/-) as indicated.
4. Slide the battery tray back into the slot in the remote control.
• Precautions Concerning Batteries
•
When the Remote Control is not to be used for a long time (more
than a month), remove the battery from the Remote Control to
prevent it from leaking.
prevent it from leaking.
•
If the batteries leak, wipe away the leakage inside the battery
compartment and replace the batteries with new ones.
•
Do not use any batteries other than those specified.
•
Do not heat or disassemble batteries.
• Never throw them in fire or water.
•
Do not carry or store batteries with other metallic objects. Doing so could cause batteries to short
circuit, leak or explode.
•
Never recharge a battery unless it is confirmed to be a rechargeable type.
A
B
Placement and Mounting
• Normal Placement (place Soundbar on
leveled surface in front of TV)
Wall Mounting (if using option-B)
Note:
- Installation must be carried out by qualified personnel only. Incorrect assembly can result in severe
- Installation must be carried out by qualified personnel only. Incorrect assembly can result in severe
personal injury and property damage (if you intend to install this product yourself, you must check
for installations such as electrical wiring and plumbing that may be buried inside the wall). It is the
installer’s responsibility to verify that the wall will safely support the total load of the unit and wall
brackets.
for installations such as electrical wiring and plumbing that may be buried inside the wall). It is the
installer’s responsibility to verify that the wall will safely support the total load of the unit and wall
brackets.
- Additional tools (not included) are required for the installation.
- Do not overtighten screws.
- Keep this instruction manual for future reference.
- Use an electronic stud finder to check the wall type before drilling and mounting.
1. Drill 4 parallel holes (Ø 5.5-6 mm each according to wall type) in the wall. The distance between
- Do not overtighten screws.
- Keep this instruction manual for future reference.
- Use an electronic stud finder to check the wall type before drilling and mounting.
1. Drill 4 parallel holes (Ø 5.5-6 mm each according to wall type) in the wall. The distance between
the holes should be 735 mm.
2. Firmly fix 1 dowel into each hole in the wall if necessary. Tighten the wall mount brackets on the
wall with screws and screwdriver (not included). Make sure that they are securely installed.
- If necessary, stick the Silicone pad into the brackets to balance the machine.
3. Remove the screws at the back of the unit. Install the wall mounting screws into the back of the
3. Remove the screws at the back of the unit. Install the wall mounting screws into the back of the
unit.
4. Lift the unit onto the wall mount brackets and slot into place.