Alco Electronics Ltd SBT17317B User Manual
FCC Information
This device complies with Part 15 of the FCC rules. Operation is subject to
the following two conditions:
the following two conditions:
(1)This device may not cause harmful interference, and
(2)This device must accept any interference received, including interference
(2)This device must accept any interference received, including interference
that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
WARNING:
• Changes or modifications to this unit not expressly approved by the
• Changes or modifications to this unit not expressly approved by the
party responsible for compliance could void the user’s authority to
operate the equipment.
operate the equipment.
• The AC adapter is used as disconnect device and it should remain
readily operable during intended used. In order to disconnect the unit
from the mains completely, the AC adapter should be disconnected
from the mains socket outlet completely.
from the mains completely, the AC adapter should be disconnected
from the mains socket outlet completely.
• The AC adapter of unit should not be obstructed OR should be easily
accessed during intended use.
1.
button
2. AUX button
3. LINE IN button
4.
3. LINE IN button
4.
/
/
button
5. PRESET EQ buttons
- STANDARD
- TALKS
- MOVIE
- MUSIC
REMOTE CONTROL
1.
Standby/ON button
2. SOURCE button
3.
3.
VOLUME button
4.
VOLUME button
5. OPTICAL IN Jack
6. LINE IN 3.5mm Jack
7. AUX IN R / L Jack
8. COAXIAL IN Jack
9. DC IN Jack
6. LINE IN 3.5mm Jack
7. AUX IN R / L Jack
8. COAXIAL IN Jack
9. DC IN Jack
LOCATION OF CONTROLS
LOCATION OF CONTROLS
ACCESSORIES
37” 2.1-CHANNEL
SOUNDBAR
Model: BWA18SB001
PRODUCT GUIDE
Ver.00 Rev.02/05/18
Ver.00 Rev.02/05/18
Ver.00 Rev.02/05/18
Ver.00 Rev.02/05/18
SAFETY PRECAUTIONS
SAFETY PRECAUTIONS
USING OF AC ADAPTER
1. Open the battery door.
To Change Remote Battery
Using the Remote Control
• Point the remote control at the
REMOTE SENSOR located on the
unit.
unit.
• When using this unit in very bright
light, the infrared REMOTE SENSOR
may not work properly.
may not work properly.
Battery Replacement
When the battery becomes weak, the operating distance of the remote
control will be greatly reduced and you will need to replace the battery.
Note: If the remote control is not going to be used for a long time, remove
the battery.
control will be greatly reduced and you will need to replace the battery.
Note: If the remote control is not going to be used for a long time, remove
the battery.
WARNING:
• Do not dispose of the battery in a fire or it may leak and/or explode.
• Batteries should not be exposed to excessive heat such as sunshine,
• Do not dispose of the battery in a fire or it may leak and/or explode.
• Batteries should not be exposed to excessive heat such as sunshine,
fire or the like.
CAUTION:
• Danger of explosion if battery is incorrectly replaced. Replace only with
• Danger of explosion if battery is incorrectly replaced. Replace only with
the same or equivalent type.
Remove the plastic sheet
before operating the
remote control.
before operating the
remote control.
2.
Insert one CR2025 (3V) size
battery.
battery.
Connect the included AC adapter to the Soundbar and the wall outlet.
Using an AC adapter other than the one supplied with the unit may
damage the unit.
Using an AC adapter other than the one supplied with the unit may
damage the unit.
WARNING - DO NOT INGEST BATTERY. CHEMICAL BURN HAZARD.
10. BLUETOOTH LED Indicator
AUX IN LED Indicator
DIGITAL IN
1. OPTICAL IN LED indicator
will illuminate when selected
will illuminate when selected
2.
COAXIAL IN LED indicator
will flash slowly when selected
LINE IN LED Indicator
11. Remote Sensor
Soundbar
Remote Control
6. OPTICAL button
7.
7.
MUTE button
8. BLUETOOTH (BT) button
9. COAXIAL button
10.
9. COAXIAL button
10.
SOURCE button
11. VOL / button
• Minimum 10 cm (4 inches) distances around the unit for sufficient
ventilations.
• The ventilation should not be impeded by covering the ventilation
openings with items such as newspaper, table-cloths, curtains, etc.
• No naked flame sources such as lighted candles should be placed on
the unit.
On Safety
• Should any objects or liquids fall into the unit, disconnect the power
supply and have the unit checked by qualified personnel before any
further operation.
further operation.
• The unit shall not be exposed to dripping or splashing and that no
objects filled with liquid, such as vases, shall be placed on the unit.
On Use
Never use the unit where it would be subject to:
- Heat sources such as radiators or air ducts.
- Direct sunlight.
- Heat sources such as radiators or air ducts.
- Direct sunlight.
BASIC OPERATION
1. Press
button on the Soundbar or button on the remote to turn on
the unit.
2. Press SOURCE button on the Soundbar or remote to select AUX IN,
OPTICAL IN, COAXIAL IN, LINE IN or Bluetooth source (input). The
LEDs located on top of Soundbar will indicate the currently-selected
source, for COAXIAL IN, the LED indicator will flash slowly when
selected.
source, for COAXIAL IN, the LED indicator will flash slowly when
selected.
3. Press the preset EQ buttons on the remote control (STANDARD, TALKS,
MOVIE and MUSIC) to obtain your desired sound effect.
Note: When mute is enabled, the 4 LED indicators will flash. Press the
MUTE button on the remote control to disable the mute function and LED
flashing stop.
MUTE button on the remote control to disable the mute function and LED
flashing stop.
- 1 -
- 5 -
- 4 -
- 2 -
- 6 -
- 3 -
- 1 -
Please locate the included accessories.
Remote control with battery ............................x 1
AC power adapter ............................................x 1
• The remote control supplied with this product contains a coin/button
cell battery. If the coin/button cell battery is swallowed, it can cause
severe internal burns in just 2 hours and can lead to death.
severe internal burns in just 2 hours and can lead to death.
• Keep new and used batteries away from children. If the battery
compartment does not close securely, stop using the product and keep
it away from children.
it away from children.
• If you think batteries might have been swallowed or placed inside any
part of the body, seek immediate medical attention.
Caution:
• Before use, ensure the rated voltage of the adapter matches your local
• Before use, ensure the rated voltage of the adapter matches your local
voltage.
• The included AC adapter is for use with this unit only. Do not use it with
other equipment.
• If you are not going to use the unit for a long time, disconnect the AC
adapter from the wall outlet.
• Whenever the AC adapter is plugged in to a wall outlet, the AC adapter
will draw some power, even when the Sound Bar is turned off.
AC adapter
TM
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated
with minimum distance 20cm between the radiator & your body