RM Acquisition LLC 01002A User Manual
8
HD 100 User Manual
Installing Your HD 100
Installing your HD 100 can take as little as 10 minutes. Install
instructions are provided here, as well as quick diagnostic
information so you can make sure your device is working correctly.
instructions are provided here, as well as quick diagnostic
information so you can make sure your device is working correctly.
Installation Kit
HD 100 Device
HD 100 Get Started Card
9-pin Power Cable
HD 100 User Manual
USB Cable
Rand McNally Hours of Service Visor Card
Adhesive Velcro Strips
Cable Ties
Installation Instructions
1. Locate the truck’s diagnostic port. Remove the plug on the
diagnostic port, connect the cable, and lock the collar and place.
2. Route cable from the diagnostic port to the area where you
would like the HD 100 to be mounted, making sure to place it
away from any vents and where it won’t interfere with driver
(the right-most corner of the dash is usually an ideal area to
place the device), tucking the cable in the space between the
windshield and the dash.
away from any vents and where it won’t interfere with driver
(the right-most corner of the dash is usually an ideal area to
place the device), tucking the cable in the space between the
windshield and the dash.
3. Connect the device to the cable. You may choose to position the
device so the LEDs on the front of your device face away from
you so as to not distract while driving.
you so as to not distract while driving.
4. Wipe the dash area where you would like to place the HD 100
with the alcohol-based wipe, making sure the surface dries
thoroughly. Peel the protective layer off one side of the Velcro
strips and place on the bottom of the HD 100 device, then peel
the other protective layer and place the device on your dash in
the desired location, pressing firmly to secure it to the
thoroughly. Peel the protective layer off one side of the Velcro
strips and place on the bottom of the HD 100 device, then peel
the other protective layer and place the device on your dash in
the desired location, pressing firmly to secure it to the
dash surface.
5. Once the HD 100 is installed and connected to vehicle with
the cable, turn your truck on to accessory mode (the mode you
use to operate your radio and A/C without turning the ignition
on fully). The four lights on the side of the device should
illuminate. Check the colored LEDs on the side of your HD 100
to ensure the device is connected and running properly (Power:
Red, Wi-Fi: Amber, Cell: Green, Jbus: Blue).
use to operate your radio and A/C without turning the ignition
on fully). The four lights on the side of the device should
illuminate. Check the colored LEDs on the side of your HD 100
to ensure the device is connected and running properly (Power:
Red, Wi-Fi: Amber, Cell: Green, Jbus: Blue).
6. Turn on your TND
™
720 device. You will first see the
IntelliRoute
®
software Home Menu. Click the HD 100 button
on this screen.