Hong Fu Jin Precision Electrons Co. Ltd. MRDB20 User Manual
FCC Information to Users:
This product and it antennas must not be co-located or operated in conjunction with any other antenna or
transmitter.
Federal Communication Commission Interference Statement
.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate this equipment.
Labeling
NFC Module MIC-001 is labeled as below.
FCC ID: A8XMRDB20
The label with FCC ID is to be placed on the module. If FCC ID is not visible when the module is installed into
the system, “Contains FCC ID: A8XMRDB20” shall be placed on the outside of final host system.
Caution: Exposure to Radio Frequency Radiation
This device must not be co-located or operating in conjunction with any other antenna or transmitter.
Instructions to OEM Integrators
A User manual provided to the end user must indicate the operating requirements and conditions that must
be observed to ensure compliance with the above-mentioned FCC RF Exposure guideline.
If other radio devices are to be integrated with this module, an additional evaluation and FCC submission may
be required. Integrators are responsible for such additional evaluation and FCC submission.
the system, “Contains FCC ID: A8XMRDB20” shall be placed on the outside of final host system.
Caution: Exposure to Radio Frequency Radiation
This device must not be co-located or operating in conjunction with any other antenna or transmitter.
Instructions to OEM Integrators
A User manual provided to the end user must indicate the operating requirements and conditions that must
be observed to ensure compliance with the above-mentioned FCC RF Exposure guideline.
If other radio devices are to be integrated with this module, an additional evaluation and FCC submission may
be required. Integrators are responsible for such additional evaluation and FCC submission.
Page 3 of 4