RadioShack Corporation 4303102 User Manual

Page of 7
Cat. No. 43-3102
Owner’ Manual
900MHz Wireless Intercoms
THE FCC WANTS YOU TO KNOW
This device complies with Part 15 of the FCC Rules.   Operation is subject to the following
two conditions:  (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired
operation.
Warning:  Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules.  These limits are designed to provide
reasonable protection against harmful interference in a residential installation.  This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a particular installation.  If
this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
 
 
Reorient or relocate the receiving antenna.
 
 
Increase the separation between the equipment and receiver.
 
 
Connect the equipment into an outlet on a circuit different from that to which the receiver is
needed.
 
 
Consult the dealer or an experienced radio/TV technician for help.
PREPARATION
You can power your intercoms using four AA batteries (not supplied) or the supplied
AC-to-DC adapter.
Installing the Batteries
Caution: Use only fresh batteries of the required size and recommended type. Do not
mix old and new batteries, different types of batteries (standard, alkaline, or
rechargeable), or rechargeable batteries of different capacities.
1.
 
Remove the battery compartment door by sliding it toward the bottom of the unit.
2.
 
Place four AA batteries in the compartment according to the polarity symbols (+ and
-) marked inside.