RadioShack Corporation 610140R User Manual

Please read this user’s guide before

installing, setting up and using your new product

www.radioshack.com

Thank you for purchasing your Two-Bell Wireless
Door Chime from RadioShack. You can use it as a
doorbell, remote pager and panic switch.

61-2117

Two-Bell Wireless

Door Chime

wireless door chime

remote doorbell 1

remote mounting brackets (2)

remote doorbell 2

lanyard (strap)

user’s guide

M 3 screw* (4)

M 2.6 brass

screw* (2)

M 3.5 screw* (5)

anchor* (5)

* all screws shown at actual size

Mount your chime on a wall...

Drill a 1/4-inch hole and insert an anchor.

Screw an M3.5 screw into the anchor,

leaving the head extended about 1/8-inch.

Align the chime’s rear keyhole slot to the

screw head and slide the chime down.

OR set your chime on a fl at surface using the

supplied stand

drill

fl athead screwdriver

C battery (3)*

AAA battery (6)*

*Batteries not supplied

wireless door chime

remote doorbell

1/4"

Install 3 C batteries in your wireless door

chime.

Install 3 AAA batteries in each remote

doorbell.

Use only fresh batteries of the required size
and type.

Remove old or weak batteries that might leak
and damage electronic circuits.

Don’t mix old and new batteries or battery
chemistries.

NOTE

carry a doorbell with you as a panic alarm or
to let someone you frequently visit (such as an
elderly parent) know you have arrived coming...
OR mount your doorbell

Mark two holes using your doorbell holder.

Drill a 1/4-inch hole at each mark.
Insert an anchor in each hole.

Align your doorbell holder with the anchors

and screw an M3.5 screw into each anchor.

Slide your doorbell into the holder. To lock

the doorbell in place, insert an M2.6 screw
into the bottom of the doorbell holder.

1/4"

61-140