Motorola Solutions Inc. MCRB10 External Photos
APPLICANT: MOTOROLA
EQUIPMENT TYPE: ABZMCRB10
December 14, 2010
To:
To:
Elite Electronic Engineering
Re: Identification
Change
for
iDEN Multi-Carrier– Dual Band – Radio Blade Transmitter
Per CFR 47, Paragraph 2.933, Motorola respectfully requests a change in identification for the indicated
transmitter.
The affected transmitter is as follows:
Existing FCC ID
Lower (MHz)
Upper (MHz)
New FCC ID
PURMCRB10 851.0125
868.9875
ABZMCRB10
935.1875
939.98125
(1) The original identification used
The original identification used for the transmitter is PURMCRB10. This is a dual band, multi-channel radio blade
transmitter that is used in iDEN systems.
(2) The date of the original grant
The date of the original grant of equipment authorization is 04/17/2006.
(3) How the equipment bearing the modified identification differs from the original equipment
The change requested is in identification only. There is no change in design, circuitry, or construction of the unit
other than company logos and labeling. The equipment has the Motorola logo / name rather than the
RadioFrame Networks logo and name. The identification label also contains ‘Motorola’ as well as the updated
FCC identification number, ABZMCRB10.
(4) Whether the original test results continue to be representative / applicable
All original test results currently on file with the commission are applicable and are representative of current and
future shipping product. The equipment will be completely compatible and interchangeable with the existing
equipment previously shipped by RadioFrame Networks. The form, fit, and function of the equipment is identical.
(5) Exterior appearance photographs
An image of the new label is shown below. The FCC ID label goes on the outside surface of the housing, on the
front of the radio blade assembly. An external photograph of the unit is shown on the following page.