Panasonic Corporation of North America 9TGCF-27GPRS User Manual
PCPD-01-F106
FCC ID: ACJ9TG-27GPRS
FCC ID: ACJ9TG-27GPRS
INSTRUCTION MANUAL
FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
connected.
•
Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation
Warning: To assure continued compliance, use only shielded interface cables when connecting computer
to peripheral devices. Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.
Responsible Party:
Matsushita Electric Corporation of America
One Panasonic Way
Secaucus, NJ 07094
One Panasonic Way
Secaucus, NJ 07094
Tel No: 1-800-LAPTOP-5 (1-800-527-8675)
Notebook Computer Operating Instructions will include the following type user information regarding RF
exposure when provided with GSM Module TX FCC ID: ACJ9TGCF-27GPRS:
Caution - To comply with FCC RF Exposure Requirements:
•
Maintain minimum 2.2 cm spacing between computer mounted antenna and person’s body
during wireless mode of operation.
during wireless mode of operation.
•
Optional vehicle mounted antenna must not exceed 3 dBi antenna gain and should be
professionally installed. Maintain minimum 20 cm spacing between vehicle mounted
antenna and person’s body during wireless mode of operation.
professionally installed. Maintain minimum 20 cm spacing between vehicle mounted
antenna and person’s body during wireless mode of operation.
•
This computer is provided with PCMCIA slots that could be used with wireless transmitters,
which will be specifically recommended, when they become available. Other third-party
wireless transmitters have not been RF exposure evaluated for use with this computer and
may not comply with FCC RF exposure requirements.
which will be specifically recommended, when they become available. Other third-party
wireless transmitters have not been RF exposure evaluated for use with this computer and
may not comply with FCC RF exposure requirements.