ICOM 325100 User Manual

vi

QUICK REFERENCE GUIDE

■ Your fi rst contact

Now that you have your IC-2300H installed in your car 
or shack, you are probably excited to get on the air. We 
would like to take you through a few basic operation 
steps. 

Before turning ON your IC-2300H, make sure the au-
dio volume and squelch level controls are set to 9–10 
o’clock.

Set both [VOL] and [SQL] to 
the 9–10 o’clock position.

Although you have purchased a brand new transceiver, 
some settings may have changed from the factory de-
faults because of the QC process. The Partial Rest is 
recommended to start with factory default settings.

[SCAN] (V/MHz)

➥  While holding down [V/MHz], hold down [ ] for 1 sec-

ond to reset the CPU.

2. Tune the desired frequency
[DIAL] will allow you to set the frequency you want to op-
erate on. Page 6 explains how to set the tuning speed.

You can directly enter the frequency with the HM-133V 
keypad. 

[i.e.]: Setting the frequency to 145.3625 MHz.

Push

Push

Push

Push

■ Repeater operation

Hold down [DUP] (LOW) for 1 second one or more 
times to select minus duplex or plus duplex.

•  The USA version has an Auto Repeater function, therefore, setting 

duplex is not required.

If accessing the repeater, requires a subaudible tone, 
push [TONE] one or more times until “ ” appears.

Using the HM-133V
Plus or minus duplex selection and the repeater tone 
setting can easily be made using the HM-133V.
Push  [

–] for minus duplex; [

 for plus 

duplex selection, then push [FUNC] 

, and then 

–] to turn ON the repeater tone.

Push

Push          , then 

Push