ICOM 357600 User Manual

Page of 5
INSTRUCTIONS
IP ADVANCED RADIO SYSTEM 
COMMUNICATION TERMINAL
IP100H
Thank you for purchasing the IP100H 
ip
 
communica
-
tion
 
terminal
.
Please read these instructions carefully before oper-
ating the communication terminal.
EXPLICIT DEFINITIONS
WORD
DEFINITION
RDANGER!
Personal  death,  serious  injury  or  an  explo-
sion may occur.
RWARNING!
Personal injury, fire hazard or electric shock 
may occur.
CAUTION Equipment damage may occur.
NOTE
If  disregarded,  inconvenience  only.  No  risk 
of personal injury, fire or electric shock.
SUPPLIED ACCESSORIES
Battery pack
Antenna 
connector cap
Antenna
Belt clip
Hand strap
1-1-32 Kamiminami, Hirano-ku, Osaka 547-0003, Japan
A-7120H-1EX-q  Printed in Japan
 
© 2014  Icom Inc.
PRECAUTIONS
PRECAUTIONS (Continued)
DANGER! NEVER
 solder the battery terminals, or 
NEVER
 
modify the battery pack. This may cause heat generation, and the 
battery may burst, emit smoke or catch fire.
R  DANGER!
  Use  the  battery  only  with  the  communication  ter-
minal for which it is specified. Never use a battery with any other 
equipment, or for any purpose that is not specified in this instruc-
tion manual.
R  DANGER!
  If  fluid  from  inside  the  battery  gets  in  your  eyes, 
blindness can result. Rinse your eyes with clean water, without rub-
bing them, and see a doctor immediately.
WARNING!
 Immediately stop using the battery if it emits an 
abnormal  odor,  heats  up,  or  is  discolored  or  deformed.  If  any  of 
these conditions occur, contact your Icom dealer or distributor.
WARNING!
 Immediately wash, using clean water, any part of 
the body that comes into contact with fluid from inside the battery.
R  WARNING!  NEVER
  put  the  battery  in  a  microwave  oven, 
high-pressure  container,  or  in  an  induction  heating  cooker.  This 
could cause a fire, overheating, or cause the battery to rupture.
CAUTION:
 Always use the battery within the specified tempera-
ture range, –10°C to +60°C (+14°F to +140°F). Using the battery out 
of its specified temperature range will reduce the battery’s perfor-
mance and battery life.
CAUTION:
  Shorter  battery  life  could  occur  if  the  battery  is  left 
fully charged, completely discharged, or in an excessive tempera-
ture environment (above +50°C; +122°F) for an extended period of 
time. If the battery must be left unused for a long time, it must be de-
tached from the terminal after discharging. You may use the battery 
until the battery indicator shows half capacity, then keep it safely in 
a cool dry place at the following temperature range:
  –20°C (–4°F) to +50°C (+122°F) (within a month)
  –20°C (–4°F) to +35°C (+95°F) (within three months)
  –20°C (–4°F) to +20°C (+68°F) (within a year)
BE SURE to replace the battery with a new one after five years, 
even if still holds a charge. The inside battery material will deterio-
rate after a period of time, even with little use.
Charging caution
DANGER! NEVER
 charge the battery pack in areas with ex-
tremely high temperatures, such as near fires or stoves, inside a 
sun-heated vehicle, or in direct sunlight. In such environments, the 
safety/protection circuit in the battery will activate, causing the bat-
tery to stop charging.
WARNING! DO NOT
 charge or leave the battery in the bat-
tery charger beyond the specified time for charging. If the battery is 
not completely charged by the specified time, stop charging and re-
move the battery from the battery charger. Continuing to charge the 
battery beyond the specified time limit may cause a fire, overheat-
ing, or the battery may rupture.
WARNING! NEVER
 insert the communication terminal (bat-
tery attached to the communication terminal) into the charger if it is 
wet or soiled. This could corrode the battery charger terminals or 
damage the charger. The charger is not waterproof.
CAUTION: NEVER
 charge the battery outside of the specified 
temperature range: 
  BC-202:  ±0°C to +40°C (+32°F to +104°F)
  BC-211:  +10°C to +40°C (+50°F to +104°F)
Icom recommends charging the battery at +25°C (+77°F). The bat-
tery may heat up or rupture if charged out of the specified temper-
ature range. Additionally, battery performance or battery life may 
be reduced.
IP100H and Bluetooth
®
 Interference
Bluetooth
®
 uses the 2.4 GHz band. When using the IP100H in the 
2.4  GHz  band  near  a  Bluetooth
®
  device,  interference  may  occur. 
This may cause a decrease in communication speed, and an un-
stable connection.
In  such  case,  use  the  IP100H  away  from  the  Bluetooth
®
  device 
communication area, or stop using the Bluetooth
®
 device.
RECOMMENDATION
CLEAN  THE  COMMUNICATION  TERMINAL 
THOROUGHLY  WITH  FRESH  WATER  after 
exposure to saltwater. Otherwise, the commu-
nication terminal's keys, switches and control-
lers may become inoperable due to salt crys-
tallization.
FCC INFORMATION
This device complies with part 15 of the
 FCC Rules. Operation is 
subject  to  the  following  two  conditions:  (1)  This  device  may  not 
cause harmful interference, and (2) this device must accept any in-
terference  received,  including  interference  that  may  cause  unde-
sired operation.
Changes  or  modifications  to  this  device,  not  expressly  approved 
by Icom Inc., could void your authority to operate this device under 
FCC regulations.
FOR CLASS B UNINTENTIONAL RADIATORS:
NOTE: This equipment has been tested and found to comply with 
the limits for a Class B digital device, pursuant to part 15 of the FCC 
Rules. These limits are designed to provide reasonable protection 
against harmful interference in a residential installation. This equip-
ment generates, uses and can radiate radio frequency energy and, 
if not installed and used in accordance with the instructions, may 
cause  harmful  interference  to  radio  communications.  However, 
there is no guarantee that interference will not occur in a particular 
installation. If this equipment does cause harmful interference to ra-
dio or television reception, which can be determined by turning the 
equipment off and on, the user is encouraged to try to correct the 
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
 Connect the equipment into an outlet on a circuit different from 
that to which the receiver is connected.
 Consult the dealer or an experienced radio/TV technician for 
help.
FOR CANADA
This  device  complies  with  Industry  Canada  licence-exempt  RSS 
standard(s). Operation is subject to the following two conditions: 
(1) this device may not cause interference, and (2) this device must 
accept any interference, including interference that may cause un-
desired operation of the device.
i.   the device for operation in the band 5150–5250 MHz is only for 
indoor use to reduce the potential for harmful interference to co-
channel mobile satellite systems.
ii   the maximum antenna gain permitted for devices in the bands 
5250–5350  MHz  and  5470–5725  MHz  shall  comply  with  the 
e.i.r.p. limit.
SAFETY TRAINING INFORMATION
This device was tested and approved with original accessories to 
ensure FCC Compliance. The use of third-party accessories may 
not comply with FCC RF exposure compliance requirements, and 
should be avoided.
DANGER! NEVER
 short the terminals (or charging terminals) 
of the battery pack. Also, current may flow into nearby metal objects 
such  as  a  key,  so  be  careful  when  placing  battery  packs  (or  the 
communication terminal) in bags, etc. Simply carrying with or plac-
ing near metal objects may cause shorting. This may damage not 
only the battery pack, but also the communication terminal.
DANGER!
 Use and charge only specified Icom battery packs 
with Icom terminals or Icom chargers. Only Icom battery packs are 
tested and approved for use with Icom terminals or charged with 
Icom  chargers.  Using  third-party  or  counterfeit  battery  packs  or 
chargers may cause smoke, fire, or cause the battery to burst.
WARNING RF EXPOSURE! 
This device emits Radio Fre-
quency  (RF)  energy.  Caution  should  be  observed  when  operat-
ing this device. If you have any questions regarding RF exposure 
and safety standards, please refer to the Federal Communications 
Commission  Office  of  Engineering  and  Technology’s  report  on 
Evaluating Compliance with FCC Guidelines for Human Radio Fre-
quency Electromagnetic Fields (OET Bulletin 65).
WARNING! NEVER
 hold the communication terminal so that 
the antenna is very close to, or touching exposed parts of the body, 
especially  the  face  or  eyes,  while  transmitting.  The  communica-
tion terminal will perform best if the microphone is 5 to 10 cm (2 
to 4 inches) away from the lips and the communication terminal is 
vertical.
WARNING! NEVER
 operate the communication terminal with
 
an earphone, headphones or other audio accessories at high vol-
ume  levels.  Hearing  experts  advise  against  continuous  high  vol-
ume operation. If you experience a ringing in your ears, reduce the 
volume level or discontinue use.
CAUTION: MAKE SURE
 the flexible antenna and battery pack 
are securely attached to the communication terminal, and that the 
antenna and battery pack are dry before attachment. Exposing the 
inside of the communication terminal to water will result in serious 
damage  to  the  communication  terminal.  After  exposure  to  water, 
clean the battery contacts thoroughly with fresh water and dry them 
completely to remove any water or salt residue.
CAUTION: DO NOT
 use harsh solvents such as benzine or al-
cohol to clean the communication terminal, because they can dam-
age the communication terminal’s surfaces.
DO  NOT
  operate  the  communication  terminal  near  unshielded 
electrical blasting caps or in an explosive atmosphere.
DO NOT
 use or place the communication terminal in direct sun-
light or in areas with temperatures below –10°C (+14°F) or above 
+60°C (+140°F).
DO NOT
 push the PTT unless you actually intend to transmit.
DO  NOT
  modify  the  transceiver.  The  transceiver  warranty  does 
not cover any problems caused by unauthorized modification.
BE  CAREFUL!
  The  communication  terminal  meets  IPX7*  re-
quirements for waterproof protection. However, once the communi-
cation terminal has been dropped, waterproof protection cannot be 
guaranteed because of possible damage to the communication ter-
minal’s case or waterproof seal.
* Only when the BP-271 or  BP-272 (option), flexible antenna or antenna cap 
and [ /
] cap are attached.
The  optional  BP-273  and  HM-186LS  meet  IPX4  requirements  for 
splash resistance. When it is attached, the communication termi-
nal corresponds to IPX4.
Battery caution
DANGER! DO NOT
 hammer or otherwise impact the battery. 
Do not use the battery if it has been severely impacted or dropped, 
or  if  the  battery  has  been  subjected  to  heavy  pressure.  Battery 
damage may not be visible on the outside of the case. Even if the 
surface of the battery does not show cracks or any other damage, 
the cells inside the battery may rupture or catch fire.
R  DANGER!  NEVER
  use  or  leave  battery  pack  in  areas  with 
temperatures above +60°C (+140°F). High temperature buildup in 
the battery, such as could occur near fires or stoves, inside a sun 
heated car, or in direct sunlight may cause the battery to rupture or 
catch fire. Excessive temperatures may also degrade battery per-
formance or shorten battery life.
DANGER! DO NOT
 expose the battery to rain, snow, seawa-
ter, or any other liquids. Do not charge or use a wet battery. If the 
battery gets wet, be sure to wipe it dry before using.
DANGER! NEVER
 incinerate a used battery pack since in-
ternal battery gas may cause it to rupture, or may cause an explo-
sion.