ICOM ic-2720h User Manual

27

4

REPEATER OPERATION

New2001

■ Offset frequency

When communicating through a repeater, the transmit fre-
quency is shifted from the receive frequency by an amount
determined by the offset frequency. 
Independent offset frequency can be set for each operating
frequency.

q Push [MAIN•BAND] to select the desired band (left or right)

as the main band.

• Push [MAIN•BAND] for 1 sec. then rotate the [DIAL] to select the

desired frequency band if necessary.

w Select the desired mode/channel you wish to set the offset

frequency to, such as VFO mode or memory/call channel.

• The offset frequency can be independently programmed into

each mode or channel.

e Push [SET•

] to enter set mode.

r Push [SET•

] or [LOW•PRIO] until “DUP” and offset fre-

quency appear.

t Rotate the main band’s [DIAL] to set the desired offset fre-

quency.

y Push [TONE•DTMF] to exit set mode.

z Push [BAND] to select the desired band (left or

right) as the main band.

• Enter the desired frequency via the keypad if neces-

sary.

x Select the desired mode/channel you wish to

set the offset frequency to, such as VFO mode
or memory/call channel.

• The offset frequency can be independently pro-

grammed into each mode or channel.

c Push [

SET

B(D-OFF)] to enter set mode.

v Push [

SET

B(D-OFF)] or [

ENT

C(T-OFF)] until

“DUP” and offset frequency appear.

b Push [Y] or [Z] to set the desired offset.

• Direct frequency entry from the keypad is not possi-

ble.

n Push [

CLR

A(MW)] to exit set mode.

☞NOTE: The offset frequency can be set in a memory/call

channel temporarily. However, the set frequency is cleared
once another memory channel or VFO mode is selected.
To store the offset frequency permanently, overwrite the
channel information.

Push         

SET

B

[SET•      ] 

[LOW•PRIO] 

“DUP” and offset frequency appear

IC-2720H.qxd  02.9.9 8:12  Page 27 (1,1)