ICOM ic-2720h User Manual
II
QUICK REFERENCE GUIDE
New2001
D Location
Select a location which can support the weight of the trans-
ceiver and does not interfere with driving. We recommend the
locations shown in the diagram below.
ceiver and does not interfere with driving. We recommend the
locations shown in the diagram below.
NEVER place the transceiver or remote controller where nor-
mal operation of the vehicle may be hindered or where it
could cause bodily injury.
mal operation of the vehicle may be hindered or where it
could cause bodily injury.
NEVER place the transceiver or remote controller where air
bag deployment may be obstructed.
bag deployment may be obstructed.
DO NOT place the transceiver or remote controller where hot
or cold air blows directly onto it.
or cold air blows directly onto it.
AVOID placing the transceiver or remote controller in direct
sunlight.
sunlight.
D Using the mounting bracket
q Drill 4 holes where the mounting bracket is to be installed.
• Approx. 5.5–6 mm (
1
⁄
4
″) when using nuts; approx. 2–3 mm (
1
⁄
8
″)
when using self-tapping screws.
w Insert the supplied screws, nuts and washers through the
mounting bracket and tighten.
e Adjust the angle for your suitable position.
;
;
25˚
Nut
Spring washer
When using
self-tapping
screws
self-tapping
screws
Flat washer
Mounting nut
Mounting
bracket
bracket
;;
@@
ÀÀ
;;
QQ
¢¢
;
@
À
;
Q
¢
;
@
À
;
Q
¢
;
@
À
;
Q
¢
Controller
Main unit
Main unit
Main unit
Quick reference guide
IC-2720H.qxd 02.9.9 8:12 Page II (1,1)