ICOM ic-r2 User Manual

13

5

MEMORY CHANNELS

■

q

Select memory mode with [V/M].

w

Set the memory channel to be programmed with [DIAL].

• Rotate [DIAL] while pushing [FUNC] to select a memory bank or

programmed scan edge channel.

• Non-programmed channels cannot be selected.

e

Push [V/M] to select VFO mode.

r

Set the desired frequency:

➥

Select the desired band with [BAND].

➥

Set the frequency using [DIAL].

➥

Set other data (e.g. offset frequency, duplex direction,
tone squelch frequency, etc.), if required.

t

Push [FUNC] + [

(V/M)

MW] for 1 sec. to program the se-

lected channel.

• Keep pushing for 2 sec. or more to automatically select the next

memory channel, if desired.

■

q

Select memory mode with [V/M].

w

Select the memory channel to transfer with [DIAL].

• Rotate [DIAL] while pushing [FUNC] to select a memory bank or

programmed scan edge channel.

e

Push [FUNC] + [

(V/M)

MW] momentarily to indicate memory

channels.

• Do not hold [FUNC] + [

(V/M)

MW] for more than 0.5 sec., other-

wise the memory channel contents will be transferred to VFO.

r

Rotate [DIAL] to select the channel to transfer to.

• Rotate [DIAL] while pushing [FUNC] to select a memory bank or

programmed scan edge channel.

• VFO (VF), as well as regular memory channels, can be trans-

ferred in this way.

t

Push [FUNC] + [

(V/M)

MW] for 2 sec. to transfer.

momentarily

Select memory
channel

for 1 sec.

+

+

blank channel

[EXAMPLE]: Transferring memory channel 3 (memory bank 0) to 20 (memory bank 0).