Shenzhen Compoka Electronic Technology Co. Ltd KBJ-151N User Manual

Page of 3
User's Manual
KBJ-151N
Stereo Headset
立体声蓝牙耳机
使用说明书
Bluetooth 4.0
USB charging port
Switch on: Press 3 seconds to switch on, the blue indicator
will be in(voice prompts in English). Press 2.5 seconds, it
enters into pairing mode, the red and blue indicators take 
turns to flash.(voice prompts in English); power will switch 
off automatically after 5 minutes no devices to connect .
In music mode, press it 1 time to pause, and press it 
again to play. (when phone call comes, the music will 
be off. When phone call is off, the music will continue.
Short press “volume increase”key for 1 time to increase 
volume with one point, long press to increase volume all 
the time. The voice prompts will appear when the volume 
up to the maximum.
Short press “volume Decrease”key for 1 time to decrease 
volume with one point, long press to decrease volume all 
the time (the “Du,Du ” warning sound will appear when the 
volume up to the minimum). 
10:30
90%
KBJ-151N
蓝牙
现为可被发现状态
设备
已连接
ON/OFF
蓝牙
通用
02
01
03
04
    Thank you for selecting our latest Bluetooth headset, please 
read this User's Manual carefully before you operate this 
headset, and please save this Manual for further reference.
Before operating, please read all the Safety notice to make sure 
the safe and appropriate use.
Safety Notice:
  Please observe the rules of the Country or Region which you 
  are in while driving.
  Do not disassemble or modify the headset at any reason, 
  otherwise, It may damage or burn the headset.
  If there is any quality problem, please send the headset to 
  authorized service center for repairing.
  Please keep the equipment along with all the accessories out 
  of the reach of children and pets. It will cause suffocation and 
  serious injury.
  Do not put the device under the environment which the 
  temperature is too low or too high ( Below 0℃ or over 45℃).
  Extreme temperatures will cause the device deformation,
  reduce the charging capacity and shorten the working life.
  Please do not wet the device, for the liquid can cause serious 
  damage to the device. Please do not touch the device by wet 
  hands. It is out of the maintenance range for the damage 
  caused by water.
  Please avoid closing to the eyes of children and pets when 
  using the flash indicator of the device.
  Please do not operate the device in thunderstorm weather. 
It will damage your hearing if you listen with high 
volume for a long time. It is recommended that 
only use the lowest volume which is necessary 
for speaking and listening to music.  
1. Guide
■ Headset introduction
※ 
Contents: Bluetooth Headset, USB Charging Cable, 
     User's Manual
USB Charging Cable:
2.Instruction
■ Key Function
Power
switch
Previous 
song
Next Song
Volume 
Increase
Volume 
Decrease
Play
Pause
■ 
How to connect with two Bluetooth mobile phones:
3
. Battery power of bluetooth headset displayed on Iphone
 After connected with Iphone, the battery power of the 
    headset will be displayed on the phone.
Press “function key” to receive phone call, press it 
again to end the phone call.
Press the key by twice continuously to re-dial the last 
phone number.
Press the key for 2 seconds to reject the phone call.
In the Music Mode, press it to play previous song.
In the Music Mode, press it to play next song.
90%
Headband
Silicone Sheath
Silicone ear buds
Ear arm (horn base)
LED indicator
Microphone
Automatic reset volume switch
Automatically reset previous song
Next song switch
Music play/pause
8
10
11
9
6
10
11
8
7
9
3
2
4
5
1
Power switch/
Pairing
Receive/Hang up phone call
Re-dial the last phone No
Receive
Hang up 
phone call
Switch off: Press 3 seconds to switch off, the red indicator 
flashes one time mean the device is switched off (voice 
prompts in English)
1) Turn on the bluetooth function of mobile phone 1.
2) Press "      " of bluetooth headset for 4~5 seconds, bluetooth 
    switch on and enters into pairing mode, the red and blue 
    indicators take turns to flash, make connection with phone 1 
    (English voice prompts)  
3) Press "      " for 3 seconds to switch off the headset(voice 
    prompts), and phone 1 is disconnected, meanwhile turn off 
    the bluetooth function of phone 1.
4) Return on the bluetooth headset, and make it enter into 
    pairing mode, blue and red indicator take turns to flash 
    (voice prompts)
5) Turn on the bluetooth function of phone 2, and search the 
    device KBJ-151N from the device list, and make connection
6) Turn off the headset bluetooth, and turn on again. And turn
    on the bluetooth function of both phones.The headset will 
    make connection with two mobile phones automatically