ODSONIC INTERNATIONAL CO. LIMITED HC8301 User Manual

Page of 17
FCC STATEMENT 
1.  This  device  complies  with  Part  15  of  the  FCC  Rules.  Operation  is  subject  to  the 
following two conditions: 
(1)  This device may not cause harmful interference. 
(2)  This  device  must  accept  any  interference  received,  including  interference  that 
may cause undesired operation. 
 
 
NOTE:  This  equipment  has  been  tested  and  found  to  comply  with  the  limits  for  a 
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed 
to  provide  reasonable  protection  against  harmful  interference  in  a  residential 
installation. 
This  equipment  generates  uses  and  can  radiate  radio  frequency  energy  and,  if  not 
installed  and  used  in  accordance  with  the  instructions,  may  cause  harmful 
interference  to  radio  communications.  However,  there  is  no  guarantee  that 
interference  will  not  occur  in  a  particular  installation.  If  this  equipment  does  cause 
harmful  interference  to  radio  or  television  reception,  which  can  be  determined  by 
turning  the  equipment  off  and  on,  the  user  is  encouraged  to  try  to  correct  the 
interference by one or more of the following measures: 
Reorient or relocate the receiving antenna. 
Increase the separation between the equipment and receiver. 
Connect the equipment into an outlet on a circuit different from that to which the 
receiver is connected. 
Consult the dealer or an experienced radio/TV technician for help. 
 
FCC Radiation Exposure Statement: 
This  equipment  complies  with  FCC  radiation  exposure  limits  set  forth  for  an 
uncontrolled  environment.  In  order  to  avoid  the  possibility  of  exceeding  the  FCC 
radio  frequency  exposure  limits,  Human  proximity  to  the  antenna  shall  not  be  less 
than 20cm(8 inches) during normal operation. 
2. Changes or modifications not expressly approved by the party responsible for compliance could 
void the user's authority to operate the equipment.