SEA Electronics LTD. SEA012 User Manual
Sea Electronics Ltd.
SEA012 user’s manual
1
SEA Wireless Charger User’s Manual
Quick Instructions:
1. Plug the adaptor into the wall (110V/60Hz or 220V/50Hz). Connect the 19VDC adaptor
output to the DC input jacket of the wireless charger plate. The blue LED of the charger
plate will be turned on for a second and then turned off. The charger plate is now ready
for charging (“waiting mode”).
plate will be turned on for a second and then turned off. The charger plate is now ready
for charging (“waiting mode”).
2. Put the Qi‐compatible cell phone or other Qi‐compatible mobile devices on top of the
central induction area where the QI logo is marked. The blue LED will be turned on when
the charger starts charging the cell phone or mobile devices. The LED will be kept on
during the charging process.
the charger starts charging the cell phone or mobile devices. The LED will be kept on
during the charging process.
3. When the battery of the mobile device is fully charged, the charger will stop charging
and turn the blue LED off. During the charging process, whenever the mobile device is
removed from the charging plate, the charging process will be terminated automatically;
the charger will be back in waiting mode and the blue LED will be off.
removed from the charging plate, the charging process will be terminated automatically;
the charger will be back in waiting mode and the blue LED will be off.
Note:
The charger only supports QI compatible cell phone or mobile devices.
When place the mobile device on top of the charging plate, please align the receiving
When place the mobile device on top of the charging plate, please align the receiving
antenna of the cell phone with the transmitting antenna of the charging plate (“QI”
mark in the plate). If the alignment is off more than 5mm‐10mm, the charging may not
start or the cell phone may indicate “The charging device is not compatible”. In this
case, please relocate the mobile device or cell phone on top of the charging plate.
mark in the plate). If the alignment is off more than 5mm‐10mm, the charging may not
start or the cell phone may indicate “The charging device is not compatible”. In this
case, please relocate the mobile device or cell phone on top of the charging plate.
When the mobile device is removed from the charging plate, the charging process will
terminate immediately.
During the charging process, the induction area of the charging plate will be heated up.
It is normal as long as the temperature is below 60℃.
Specifications
Adaptor: AC input 110V~220V, 50Hz~60Hz; DC output 19V/0.5A
Wireless charger output: 5V/1A
Wireless charger operation frequency: 105KHz~205KHz
Maximum charging plate temperature: <60℃
Wireless charger output: 5V/1A
Wireless charger operation frequency: 105KHz~205KHz
Maximum charging plate temperature: <60℃
Regulatory and compliance
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
must accept any interference received, including interference that may cause undesired
operation.
changes or modifications not expressly approved by the party responsible for