Vivint. Inc. CP02 User Manual
Configure System Settings: Reporting and Troubles Settings
- 45 -
Reporting and Troubles Settings
This section contains descriptions, default values, and notes about the Reporting and Troubles settings.
To access these settings from the control panel, go to:
To access these settings from the control panel, go to:
Menu > Settings > Installer Toolbox > Reporting and Troubles
From the Networking screen, you can view and configure the following settings.
Programming Mode Entry Reports to CS
DEFAULT: Disabled
A report can be sent to the Central Station any time programming (i.e., system settings configuration in the
Installer Toolbox) mode is entered and exited.
l
The default setting prevents reporting programming mode entry and exit.
l
To report programming mode entry and exit, select enabled.
Trouble Reports to CS
DEFAULT: Enabled
Trouble reports can be sent to the Central Station when any sensor trouble condition occurs.
l
The default setting allows reporting sensor trouble conditions.
l
To not report sensor trouble conditions, select disabled.
NOTE: This setting does not affect trouble reports caused by control panel conditions, only trouble reports caused
by sensors.
Trouble Restore Reports to CS
DEFAULT: Enabled
Trouble restore reports can be sent to the Central Station when any sensor trouble condition clears.
l
The default setting allows trouble restore reports.
l
To turn off trouble restore reports, select disabled.
Manual Bypass Reports to CS
DEFAULT: Disabled
Manual bypass reports can be sent to the Central Station when any sensor has been manually bypassed by the
user.