CBF Networks Inc. dba Fastback Networks 107 User Manual
IBR Installation Guide
Page 10 of 21
Doc # 770-00033.0
Jan. 22, 2016
Fiber SFP modules may be either single mode or multimode and must be the industrial temperature variants
that support operating temperatures from -40°C to +85°C.
The RJ-45 connector(s) will accept shielded and bonded RJ-45 type mating connectors with a weatherproof
The RJ-45 connector(s) will accept shielded and bonded RJ-45 type mating connectors with a weatherproof
seal.
The AC power connector is active only on IBR-1301 and is plugged on IBR-1300.
NOTE: It is essential that only weatherproof connectors be connected to IBR.
The side where the mounting lugs and Ethernet connectors are located is referred to as the “back”, since it is
The AC power connector is active only on IBR-1301 and is plugged on IBR-1300.
NOTE: It is essential that only weatherproof connectors be connected to IBR.
The side where the mounting lugs and Ethernet connectors are located is referred to as the “back”, since it is
the side that will be against a wall or mast when IBR is mounted.
2.4
Power Requirements
IBR-1300 and IBR-1301 each require forty-one (41) watts of input power.
IBR-1300 requires PoE
IBR-1300 and IBR-1301 each require forty-one (41) watts of input power.
IBR-1300 requires PoE
+
furnished through ge0. Fastback recommends that power to IBR-1300 be provided
over four (4) pairs. Based on an estimated loss of five (5) watts in a one hundred meter run of Ethernet cable,
the power injector for PoE
+
should be capable of delivering at least forty-six (46) watts across its rated
temperature range.
Applying PoE
Applying PoE
+
through ge1 will cause no harm, but will not power IBR. IBR does not have a capability to
provide PoE to other devices.
IBR-1301 requires 90-240 VAC applied to a power connector that is installed only on IBR-1301. This
IBR-1301 requires 90-240 VAC applied to a power connector that is installed only on IBR-1301. This
connector (GT153210) is illustrated below.
Figure 5 – AC Power Connector
A six meter cable with a mating connector on one end and unterminated on the other end is available from
Fastback Networks. Wire colors in this cable are black (line), white neutral, and green (ground). This cable is
shown below.
Figure 6 – Available AC Power Cable
Note: AC power to IBR-1301 should be installed by qualified personnel and in compliance with all applicable
codes.
2.5
LEDs
Two LEDs on the ge0 RJ-45 jack provide power and system information; however, these LEDs are not visible
Two LEDs on the ge0 RJ-45 jack provide power and system information; however, these LEDs are not visible
when an RJ-45 connector with weatherized boot is connected to the jack. Viewing these LEDs may require