CBF Networks Inc. dba Fastback Networks LIB-V1000E2 User Manual

Page of 85
Liberator-V1000 User Manual 
Rev 04v05
 
 
 
 
 
Page 
7
 of 
85
  
FBN Doc #: FBN-0125_04v05
 
power supply is the primary disconnect device for the Liberator-V1000. The installer must ensure that a 
mains voltage supply cable approved for the country of installation is used. 
WARNING: It is strongly advised to first disconnect any network cable attached to the “IN” port of the PoE
++
 
supply before:  
 
Connecting or disconnecting the PoE
++
 supply from the mains power 
 
Connecting or disconnecting the CAT5e cable between the PoE
++
 supply and the radio terminal (ODU). 
1.3.5 
 
Maintenance and Servicing 
 
Always disconnect the primary power source before undertaking maintenance/repair of the radio 
terminal (Outdoor Unit). 
 
At least once per year, each radio terminal (Outdoor Unit) must be inspected for signs of corrosion.  Light 
corrosion is acceptable in extreme environmental conditions (marine-type deployments), but the 
structural integrity of the Outdoor Unit must not be in doubt.  In the unlikely event that significant 
corrosion is seen, the radio terminal may need to be replaced: in this case, please contact Sub10 Systems 
for advice. 
1.4 
Warranty 
Sub10 Systems warrants to the original end user (purchaser) that this product is free from any defects in 
materials or workmanship for a period of up to 24 months (2 years) from the date of shipment to the end 
user. During the warranty period and upon proof of purchase, should the product show indications of failure 
due to faulty workmanship and/or materials, Sub10 Systems will, at its discretion, repair or replace the 
defective products or components without charge for either parts or labor and to whatever extent it shall 
deem necessary to restore the product or components to full operating condition. Any replacement will 
consist of a new or remanufactured, functionally equivalent product of equal value, and will be offered solely 
at the discretion of Sub10 Systems. 
This warranty shall not apply if the product is modified (e.g. warranty seal is broken), misused, tampered 
with, damaged by an act of God, or subjected to abnormal working conditions. To obtain services under this 
warranty, contact the Sub10 Systems Service Centre. Products must be returned postage prepaid. It is 
recommended that the terminal be insured when shipped. Any products returned without either proof of 
purchase or with an outdated warranty will not be repaired or replaced. The customer will be billed for parts 
and labour. All repaired or replaced products will be shipped by Sub10 Systems to the corresponding return 
address ‘postage paid’. If the customer specifies an alternative return destination where additional costs are 
incurred, the customer shall bear the cost of the additional return shipment cost. This warranty gives you 
specific legal rights, and you may also have other rights that vary from country to country.