upvel LLC UA-210WN User Manual

 

FCC Caution: Any changes or modifications not expressly approved by the party responsible 

for compliance could void the user's authority to operate this equipment. 

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two 

conditions: (1) This device may not cause harmful interference, and (2) this device must 

accept any interference received, including interference that may cause undesired operation. 

 

NOTE: This equipment has been tested and found to comply with the limits for a 

Class B digital device,  pursuant to Part 15 of the FCC Rules.  

These limits are designed to provide reasonable protection against harmful interference in a 

residential installation. This equipment generates, uses and can radiate radio 

frequency energy and, if not installed and used in accordance with the 

instructions, may cause harmful interference to radio communications.  

However, there is no guarantee that interference will not occur in a particular installation. 

If this equipment does cause harmful interference to radio or television reception, 

which can be determined by turning the equipment off and on, the user is encouraged to  

try to correct the interference by one or more of the followingmeasures: 

-- Reorient or relocate the receiving antenna. 

-- Increase the separation between the equipment and receiver. 

-- Connect the equipment into an outlet on a circuit different from that to which the 

 receiver is connected. 

-- Consult the dealer or an experienced radio/TV technician for help. 

FCC RF Radiation Exposure Statement: 

1. This Transmitter must not be co-located or operating in conjunction with any other 

antenna or transmitter. 

2. This equipment complies with FCC RF radiation exposure limits set forth for an 

uncontrolled environment. This device was tested for typical hand held operations with 

the device contacted directly to the human body to the sides of the device. To maintain 

compliance with FCC RF exposure compliance requirements, avoid direct contact to the 

transmitting antenna during transmitting.