DongGuan Mae Tay Electronic Co. Ltd 1913812 User Manual

Page of 6
 
 
Federal Communication Commission Interference Statement 
 
This equipment has been tested and found to comply with the limits for a Class B 
digital device, pursuant to Part 15 of the FCC Rules.  These limits are designed 
to  provide  reasonable  protection  against  harmful  interference  in  a  residential 
installation.  This  equipment  generates,  uses  and  can  radiate  radio  frequency 
energy  and,  if  not  installed  and  used  in  accordance  with  the  instructions,  may 
cause  harmful  interference  to  radio  communications.    However,  there  is  no 
guarantee  that  interference  will  not  occur  in  a  particular  installation.    If  this 
equipment does cause harmful interference to radio or television reception, which 
can be determined by turning the equipment off and on, the user is encouraged 
to try to correct the interference by one of the following measures: 
 
Reorient or relocate the receiving antenna. 
Increase the separation between the equipment and receiver. 
Connect the equipment into an outlet on a circuit different from that 
to which the receiver is connected. 
Consult the dealer or an experienced radio/TV technician for help. 
 
FCC Caution: Any changes or modifications not expressly approved by the party 
responsible  for  compliance  could  void  the  user's  authority  to  operate  this 
equipment. 
 
This device complies with Part 15 of the FCC Rules. Operation is subject to the 
following two conditions: (1) This device may not cause harmful interference, and 
(2) this device must accept any interference received, including interference that 
may cause undesired operation. 
 
IMPORTANT NOTE: 
Radiation Exposure Statement: 
The  product  comply  with  the  US  portable  RF  exposure  limit  set  forth  for  an 
uncontrolled environment and are safe for intended operation as described in this 
manual.  The  further  RF  exposure  reduction  can  be  achieved  if  the  product  can 
be  kept  as far as  possible from  the  user  body  or  set  the  device  to  lower  output 
power if such function is available. 
 
This transmitter must not be co-located or operating in conjunction with any other 
antenna or transmitter.