CEI Conrad Electronic International Limited RCE-NAVIGATOR User Manual

36  |  Status Indication Table

Flight Mode

Basic (ACC assisted)

Channel 5 : (+100)

 Magenta

Dimming – On/Off

None

Expert

Channel 5 : (0)

 Orange

Dimming – On/Off

None

GPS (position hold)

GPS fixed - No signal (without Homelock)

Refer to chapter ”GPS”

Dimming – On/Off

Dimming – On/Off

Double beep, 2s pause (can be disabled via APP)

GPS fixed - Poor signal (with Homelock)

Refer to chapter ”GPS”

Dimming – On/Off

Dimming – On/Off

Single long beep at take-off

Channel 5 : (-100), strong GPS signal (with Homelock)

Refer to chapter ”GPS”

Dimming – On/Off

None

Flight agility 
(Bank selection switch)

Channel 6

No indication

Dimming – On/Off

None

R.T.H. Return-to-Home

Channel 5 triggered via switch or Transmitter (Tx) off

White – Blinks continuously (0.5 Hz)

Same as buzzer

Same as buzzer

Double beep, 1.5 sec pause.
Long beep at every step of the process.

Lost locator

SWA (Channel 7) or Hard impact (crash or hard landing)

According to flight mode

S.O.S

S.O.S

S.O.S

Flight Error

Low battery level 1

Battery <11.4 V

White – Blinks continuously (1 Hz)

Single flash, 1s pause

Single flash, 1s pause

Single beep, 2s pause

Low battery level 2

Battery <10.5 V (pilot must land !)

White – Blinks continuously (5 Hz)

Flashing 2 Hz

Flashing 2 Hz

Continuous double beeps (1 Hz)

Fail safe (PPM failed)

Loss of RF signal

 White – Blinks continuously (0.5 Hz)

Dimming – On/Off

Long beep at each stage of process

Flight Check Error

GPS / compass failed

Start up main board self test

Red – Blinks continuously (1 Hz)

Dimming – On/Off

None

Pressure sensor failed
Gyro failed
Power system failed 
(ESC/motor)
Permanent system check

System error (pilot must land!)

Red – Blinks (fast)

Flashing 5 Hz

Flashing 5 Hz

Continuous single beeps (5 Hz)

Calibration

Tx

Calibration button

 Red

Flashing – According to steps

Flashing – According to steps

None

Gyro

Calibration button

 Green

Flashing – According to steps

Flashing – According to steps

None

Compass

Calibration button

 Magenta

Flashing – According to steps

Flashing – According to steps

None

Pairing

BLE Pairing

Pairing button

According to flight mode

Double flash 1 Hz

Solid ON

None

Factory state

Gyro or compass calibration procedure

Invalid gyro or compass calibration

Cyan – Blinks 1Hz (alternating to rear)

Dimming – On/Off

None