Shenzhen Minde Electronics Technology LTD. MS3390 User Manual
37
7 Barcode programming instructions
Note: Throughout the programming bar code menus, the factory default settings are indicated with
asterisks (*).
asterisks (*).
7-1 Example: Programming
Refer to the next page, the steps of programming are:
1. Scan the SETUP bar code on the parameter setting part.
2. Enter the option mode by scanning the Option bar code.
3. To the right of the option barcode, the necessary alphanumeric inputs are listed. Scan these
1. Scan the SETUP bar code on the parameter setting part.
2. Enter the option mode by scanning the Option bar code.
3. To the right of the option barcode, the necessary alphanumeric inputs are listed. Scan these
alphanumeric entries.
4. Scan the END bar code, listed on the lower right hand corner of each parameter setting part.
Notes:
1) Only one parameter can be setup at each time.
2) During the process of programming, LED is lighting to indicate the programming correctness. LED will
Notes:
1) Only one parameter can be setup at each time.
2) During the process of programming, LED is lighting to indicate the programming correctness. LED will
go off if any incorrect programming operation performed.
3) After each successful programming, LED will go off and the scanner will beep twice.
Example: to set Flow control to be XON/XOFF.
Steps: Scan the following barcodes in order.
Example: to set Flow control to be XON/XOFF.
Steps: Scan the following barcodes in order.
SETUP
Option bar code
Option
Alpha.
entry
Flow control
None
RTS/CTS
(Host: Low RTS)
RTS/CTS
(Host: High RTS)
XON/XOFF
ACK/NAK
RTS/CTS
(Host: Low RTS)
RTS/CTS
(Host: High RTS)
XON/XOFF
ACK/NAK
00*
01
02
03
04
01
02
03
04
Inter-character delay
00-99 (ms)
00-99
00*
00*
Block trans. delay
00-99 (10 ms)
00-99
00*
00*
Response delay
00-99 (100 ms)
00-99
00*
00*
END
SETUP bar code
Alpha. entries
Option bar code
END bar code