FN-LINK TECHNOLOGY LIMITED F23BDSM43 User Manual
IMPORTANT NOTE:
This device is intended only for OEM integrators under the following conditions:
(1) According to FCC Part 15 Subpart C Section 15.212, the radio elements of the modular
transmitter must have their own shielding. However, due to there is no shielding for this WIFI/BT
module, this module is granted as a Limited Modular Approval.
transmitter must have their own shielding. However, due to there is no shielding for this WIFI/BT
module, this module is granted as a Limited Modular Approval.
(2) This module has been designed to operate with a Integral Chip antenna having a maximum
gain of 1.5dBi. Only this type of antenna may be used.
gain of 1.5dBi. Only this type of antenna may be used.
(3) Integration is typically strictly restricted to Grantee himself or dedicated OEM integrators
under control of the Grantee.
under control of the Grantee.
In the event that these conditions can not be met (for example certain laptop configurations or
co-location with another transmitter. then the FCC authorization is no longer considered valid
and the FCC ID can not be used on the final product. In these circumstances, the OEM
integrator will be responsible for re-evaluating the end product (including the transmitter) and
obtaining a separate FCC authorization.
co-location with another transmitter. then the FCC authorization is no longer considered valid
and the FCC ID can not be used on the final product. In these circumstances, the OEM
integrator will be responsible for re-evaluating the end product (including the transmitter) and
obtaining a separate FCC authorization.
The module will be responsible to satisfy SAR/RF Exposure requirements, when the module
integrated into any (portable, mobile, fixed) host device.
integrated into any (portable, mobile, fixed) host device.
This module is intended for OEM integrator only and the OEM integrators and instructed to
ensure that the end user has no manual instructions to remove or install the device. The OEM
integrator is still responsible for the FCC compliance requirement of the end product, which
integrates this module.
ensure that the end user has no manual instructions to remove or install the device. The OEM
integrator is still responsible for the FCC compliance requirement of the end product, which
integrates this module.
The module has no shielding and tested stand alone. This module is tested and approved as
Limited modular approval with stand alone configuration, any OEM incorporated this radio
module into any system are require additional testing and evaluation.
The module is only certified with the installed antenna. Any change of the antenna will void the
certification. The host device including this RF module need to undergo separate certification.
Limited modular approval with stand alone configuration, any OEM incorporated this radio
module into any system are require additional testing and evaluation.
The module is only certified with the installed antenna. Any change of the antenna will void the
certification. The host device including this RF module need to undergo separate certification.
FN-LINK TECHNOLOGY LIMITED
http://www.fn-link.com
Page17/17
The OEM integrator has to be aware not to provide information to the end use
regarding how to install or remove this RF module in the user's manual of
the end product which integrates this module. The end user manual shall
include all required regulatory information/warming as shown in this manual.
regarding how to install or remove this RF module in the user's manual of
the end product which integrates this module. The end user manual shall
include all required regulatory information/warming as shown in this manual.