Wintop Electronics Co. Limited WM-781 User Manual

Step1 open the upper cover

Step 3.Replace upper cover

Abtain the receiver on the cover

1:when you want use the mouse,you  can take out the receiver to computer by the 
   list        step;

2:when you need stop the work or to travel, you can store the receiver on the mouse
   for the moving by the list        step;

1

2

The RF2.4GHz optical mouse use one AA alkaline batteries.

Installing  Batteries in the Mouse

Step2. Insert the battery as shown  inside the battery compartment.

USB Port

CAUTION:To use this device properly,please read
                   the user’s guide before installation

1.Connect the USB piug ONLY to USB port of the  computer

Take out the receiver

Store the receiver

Model:WM781

RF2.4GHz Optical Mouse

1

2

*This mouse is equipped with Traveling-Power-Save function.
When you are traveling with this mouse, the LED of the mouse will be switched off
automatically for the purpose of power-save, but the pre-condition is that the
receiver is disconnected with your notebook or PC.

*when your mouse no any clik or scroll or moving,the mouse will cme to sleep

state for the economize after about 30 minutes, for the wake up,you can click any
button for  this 

Power-Save function:

Characteristics

FCC STATEMENT : 

This device complies with Part 15 of the FCC Rules. Operation is subject to the 

following two conditions:

(1) This device may not cause harmful interference, and (2) This device must

accept any interference received, including interference that may cause 

undesired operation.

Warning: Changes or modifications not expressly approved by the party responsible 

for compliance could void the user's authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for 

a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits 

are designed to provide reasonable protection against harmful interference 

in a residential installation. This equipment generates uses and can radiate 

radio frequency energy and, if not installed and used in accordance with 

the instructions, may cause harmful interference to radio communications. 

However, there is no guarantee that interference will not occur in a particular 

installation. If this equipment does cause harmful interference to radio or 

television reception, which can be determined by turning the equipment 

off and on, the user is encouraged to try to correct the interference by 

one or more of the following measures:

   Reorient or relocate the receiving antenna.

   Increase the separation between the equipment and receiver.

   Connect the equipment into an outlet on a circuit different from that to which the 

receiver is connected.

   Consult the dealer or an experienced radio/TV technician for help.