Cinch Systems Inc RF-MDWS-HP-S User Manual

RF-MDWS-HP-S—Installation Instructions

Wireless Sensor and Accessories

1 - RF-MDWS-HP-S Sensor 1- Mounting Tape 1 - Magnet 1 - Battery

( 3VDC CR 2)

Instructions

Tamper
switch

Doc # I-RF-MDWS-HP-S Rev A. Mar 2017

Installation
1. Remove the transmitter’s cover by pressing in on

the small rectangular latch on the end of the cover
and lift up

2. Mount the sensor base directly to the surface us-

ing the mounting tape provided. Make sure to
align the mounting tape with the tamper pull put
area on the bottom of the sensor to insure proper
tamper operation.

3. Mount the magnet next to the sensor and align

the magnet with the mark on the side of the sen-
sor, using the mounting tape provided, or connect
an external contact to the terminals

4. Remove the battery isolator tabs from both batter-

ies on the sensor

5. Replace the cover on the transmitter
6. Enroll the senor into the control panel according

the instructions

Note: Mounting the transmitter onto metal surfaces
may impact the effective range of the transmitter

Cover
Latch

Tamper
Base

Note: Battery Safety

Observe polarity when inserting
replacement battery to avoid damag-
ing the sensor.
Risk of fire, burns and explosion. Do
not recharge, disassemble, burn or
expose batteries to temperatures
above 100C (212F)
Dispose of used battery properly and
in accordance with all local laws
Keep batteries away from children

Battery