Earda Electronics Ltd EWN-1601A User Manual

 

 

5、Special version 

 

EWN-1601LNS1AA

 *** is a 

EWN-1601LNS1AA

 product, suffix‘ * * * ’is made by use of manufacturers and 

other information that has no effect on the product itself. 

 

、OEM Labeling Requirements 

 

NOTICE: The OEM must make sure that FCC labeling requirements are met. This includes a clearly visible 
exterior label on the outside of the final product housingthatdiplays the contents shown in this label. 

 

 

BRAND NAME OR TRADE NAME 

 

 

Contains FCC ID:  2ABE4EWN-1601A 

 

 

This device complies with part 15 of the FCC Rules. Operation is subject to the following 
two conditions: (1) This device may not cause harmful interference, and (2) this 
device must accept any interference received,including interference that May cause 
undesired operation. 

 

 

 

 

FCC Statement 

 

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) 
This device may not cause harmful interference, and (2) this device must accept any interference 
received,including interference that May cause undesired operation. 

 

 

FCC Caution: Any changes or modifications not expressly approved by the party Responsible for compliance 
could void the user’s authority to operate this equipment. 

 

Radiation Exposure Statement 

 

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled Environment. This 
equipment should be installed and operated with minimum distance 20cm. Between the radiator & your body. 

Attention:

This RF Module does not have an own shielding, so that a Limited Modular Approval (LMA) was granted:

 

 

This RF Module must not be sold to the general public.

The OEM integrator is still responsible for the FCC compliance requirement of the end product, which integrates 

this module. Appropriate measurements (e.g. 15 B compliance) and if applicable additional equipment authoriza-

tions (e.g. Verification , Doc) of the host device to be addressed by the integrator/manufacturer.

 under the control of the   rantee.

 and This LMA with a Integral antenna, antenna gain is 0.0dBi.

This RF module is strictly limited to the integration by the   rantee himself or the dedicated OEM integrators

G

G

Proper measurements of the host device including this RF module (radiated spurious emissions and bandedge) 

are required to assure compliance with the FCC regulations.

onal equipment authorizations (e.g. Class II Permissive Change or New Equipment Authorization) for his 

configuration.

IMPORTANT NOTE: In the event that these conditions cannot be met (for example: certain laptop configurations 

or co-location with another transmitter), then the FCC authorization is no longer considered valid and the FCC ID 

cannot be used on the final product. In these circumstances, the OEM integrator will be responsible for re-evaluating 

the end product (including the transmitter) and obtaining a separate FCC authorization. 

Changes or modifications not expressly approved by the party responsible for compliance could void the user's 

authority to operate the equipment.

Any other integrator must contact the  rantee to determine necessary compliance measurements and/or additi-

G