APC AP9618U User Manual
®
How to Upgrade a Network Management Card
Types of
upgrades
upgrades
Use the kit AP9619U to upgrade the AP9617 Network
Management Card
Management Card
EX to the AP9619 Network Management
Card
EM, which includes an integrated Environmental Monitor
and an output relay.
Use the kit AP9618U to upgrade the AP9617 Network
Management Card
Management Card
EX or AP9619 Network Management Card
EM to the AP9618 Network Management Card EM/MDM,
which includes an integrated Environmental Monitor, an
output relay, and an internal analog modem.
which includes an integrated Environmental Monitor, an
output relay, and an internal analog modem.
How to
assemble the
card
assemble the
card
1. On the bottom of your Management Card, remove and
save the two screws that hold the bracket (faceplate of
the card) in place.
the card) in place.
2. If you are upgrading the AP9619 Management Card, on
the top of the card also remove the third screw that holds
the bracket (faceplate) in place. You do not need to save
this screw.
the bracket (faceplate) in place. You do not need to save
this screw.
3. Remove the bracket (faceplate).
4. If you are upgrading the AP9619 Management Card,
hold each PCB of your card by its edge, pull the two
PCBs apart, and discard the upper board.
PCBs apart, and discard the upper board.
Caution
The Network Management Card is sensitive to
static electricity. When handling the Printed
Circuit Boards (PCBs) of the Management Card
and the upgrade kit, touch only the edges of the
PCBs and use one or more of these electrostatic-
discharge devices (ESDs): wrist straps, heel
straps, toe straps, or conductive shoes.
static electricity. When handling the Printed
Circuit Boards (PCBs) of the Management Card
and the upgrade kit, touch only the edges of the
PCBs and use one or more of these electrostatic-
discharge devices (ESDs): wrist straps, heel
straps, toe straps, or conductive shoes.