Zhongshan Yinli Electronics Co. Ltd VS-86M User Manual
User Manual
Bluetooth Vibration Speaker with Microphone
Output power: 10W
S/N: 78dB
Frequency Response : 20Hz‐20 KHz
Power supply: USB DC5V or USB power
Li‐ion Battery: 3.7V 800mAh
Impedance: 2ohms
Key Features: Bluetooth, Mircorphone, 3.5MM audio input, Touch keys.
Size: Ø60*64MM
S/N: 78dB
Frequency Response : 20Hz‐20 KHz
Power supply: USB DC5V or USB power
Li‐ion Battery: 3.7V 800mAh
Impedance: 2ohms
Key Features: Bluetooth, Mircorphone, 3.5MM audio input, Touch keys.
Size: Ø60*64MM
Features:
z
Using vibration resonance, Vibration speaker transforms any solid surface to produce sounds, it’s a full spectrum
omni‐directional speaker, delivering 10 Watts of sound with super heavy bass.
omni‐directional speaker, delivering 10 Watts of sound with super heavy bass.
● Work time: 1.5 hours, based on full blast.
z
Charging time: 2.0 hours, based on adapter of 5.0V/1.0A .
z
Connect wirelessly to any Bluetooth enabled device or via the standard 3.5mm audio socket on any audio player.
z
Works with Android or Windows Mobile Phones, Tablets, Notebooks, Projectors or any electronic gadget that plays
sound or music.
sound or music.
z
Two‐way communication between speaker and a Bluetooth phone.
Charging ‐ Important:
Before using the speaker for the first time, the battery needs to be fully charged. Please turn the switch to the
“OFF” position and then connect one end of the USB cable to the mini USB socket and the other end to the USB socket
of a PC, laptop or USB wall charger. When charging, the bottom LED turns red .The battery will be fully charged in about
2 hours and the LED will turn blue. When the upper indicator light of the top is a flash red or volume is weak, it means
the battery needs to be recharged. Follow the charging instructions above.
of a PC, laptop or USB wall charger. When charging, the bottom LED turns red .The battery will be fully charged in about
2 hours and the LED will turn blue. When the upper indicator light of the top is a flash red or volume is weak, it means
the battery needs to be recharged. Follow the charging instructions above.
Operation:
z
Remove the protective film from the bottom of the speaker whilst leaving the gel attached to the speaker. Re‐apply the
protective film when not in use. To clean the gel, use a wet cloth to gently remove any dirt. Do not get water into the
speaker.
protective film when not in use. To clean the gel, use a wet cloth to gently remove any dirt. Do not get water into the
speaker.
z
Your speaker will work by placing it on a clean surface within a room for the application you intend to use the speaker
for.
for.
z
Lightly press the top of the speaker to achieve a better connection between the gel and the sound surface.
z
Connect the cable according to the Instructions below or pair the speaker if using a Bluetooth connection.