ENPING SHENGYI ELECTRONIC CO. LTD. U-5296MH User Manual
OPERATION AND CAUTION
▲ OPERATING
1/ Connect the whole system (including receiver, amplifier, speaker, TV, DVD, ect.)
2/ Turn the volume of receiver and amplifier to “LOW” place.
3/ Turn on the whole system by turn.
4/ Turn on the transmitter.
5/ Adjust the whole system to a satisfied result.
6/ Eliminating the system according the USER”S GUIDE if the receiver contains any
2/ Turn the volume of receiver and amplifier to “LOW” place.
3/ Turn on the whole system by turn.
4/ Turn on the transmitter.
5/ Adjust the whole system to a satisfied result.
6/ Eliminating the system according the USER”S GUIDE if the receiver contains any
breakdown, or to ask those professional technician.
7/ When finish, Turn of the transmitter, then turn off the system by turn.
▲CAUTION
1/ Make sure the ANTENNA are assembled in right way, remember that to keep the
distance shorter between receiver and transmitter, the better sound result you will
catch.
2/ To avoid to put the receiver beside computer or other system with RF signal.
3/ Don’t put the receiver at the bottom of the equipment closet.
REPAIRING WITH SIMPLE FAULT
1/ Turn on the receiver, but the indicator is not lighted.
Make sure if the power cable is well fixed. Is the socket in good condition
Is the fuse blown.
2/ When you speak, the AF light twinkles, but no sound output.
Make sure if the volume keep in lowest place, or the audio cable is not fixed well.
3/ Timbre becomes bad
Check the voltage of battery, maybe you need to change the batteries.
Check the frequency, perhaps there is a same frequency disturbed around you. Do not use
two system with same frequency at the same time in a same place (Separate them at least
120m)
Make sure if the power cable is well fixed. Is the socket in good condition
Is the fuse blown.
2/ When you speak, the AF light twinkles, but no sound output.
Make sure if the volume keep in lowest place, or the audio cable is not fixed well.
3/ Timbre becomes bad
Check the voltage of battery, maybe you need to change the batteries.
Check the frequency, perhaps there is a same frequency disturbed around you. Do not use
two system with same frequency at the same time in a same place (Separate them at least
120m)
Don’t open and repair the system when some serious breakdown happens,
please contact the seller or our factory, we will do our best help you.
--7---
TECHNICAL INDEX
▲ SYSTEM
Carrier frequency range: UHF902.3MHz - 927.7MHz
Frequency Setting Mode: PLL
Modulation Mode: FM
Stability:±30ppm
Ambient temperature:-10℃ ~+40℃
Max deviation:±15KHz
Dynamic range:>90dB
S/N ratio:>98dB
T.H.D:<0.5%
Frequency response:40Hz~15KHz (±3dB)
Operating range: 60m( under typical conditions)
AF output: Mixed:0~±200mV, Balanced: 0~±400mV
▲ RECEIVER
Receiving mode: DPLL
Sensitivity:12dBu/v
Sensitivity modification range: 12~32dBu/v
:Audio output:Balanced: 0~0.5v/600k
Mixed: 0~0.5v/5k
Working Power: 600~650mA
Power adaptor: 110-120V/220-240V, 50Hz
▲ TRANSMITTER
Microphone: dynamic(Hand-held)
condenser(Body-pack Transmitter/Headset microphone)
Antenna:Built-in
Modulation : DSP
RF output: 1.006 mW (Body-pack); 0.365 mW (Hand-held)
Max Deviation: ±25KHz
Battery: 2pcs of 1.5V AA battery
Battery:6~8 hours
--8---