Building 36 Technologies LLC B36S10RA User Manual
Temperature Sensor
Product Manual
Installation
For optimal performance install the Sensor
approximately 5 feet above the floor of an
interior wall. Avoid installing the Sensor on an
exterior wall, in areas that are close to heating
or cooling vents, and areas that are exposed to
direct sunlight. The Sensor is designed for indoor
use only.
approximately 5 feet above the floor of an
interior wall. Avoid installing the Sensor on an
exterior wall, in areas that are close to heating
or cooling vents, and areas that are exposed to
direct sunlight. The Sensor is designed for indoor
use only.
1. Remove the battery tab from the Sensor.
2. Mount the Sensor on the wall using the
nail or double-sided adhesive tape
provided.
provided.
Including the Sensor (adding it to the network)
TIP: For best results, we recommend having the Hub in
the same room as the device you are Including.
the same room as the device you are Including.
1. Press the Pairing button on the Hub once
to put the Hub in Inclusion mode. The
light on the Hub will start flashing Green.
light on the Hub will start flashing Green.
• NOTE: If you are pairing this to the
Hub36 the color of the flashing light will
be Yellow.
be Yellow.
2. Press the Pairing button on the Sensor to
Include the Sensor to the network.
• When the light on the Sensor turns
solid White and the light on the Hub
turns solid Green, the Sensor has been
successfully Included.
turns solid Green, the Sensor has been
successfully Included.
• NOTE: If you are pairing this to the
Hub36 the color of the solid light will be
Yellow.
Yellow.
If you are using the
first version of the Hub
(Hub 36), see the notes
below each instruction.
first version of the Hub
(Hub 36), see the notes
below each instruction.
Hub36
pairing
button
Box Contents:
Temperature Sensor
CR123 Battery
Nail
Double-sided Adhesive Tape
Double-sided Adhesive Tape