Practical House SRUSV1 User Manual

Before first use, you will need to initialize your Smart-Reader. Please check your Smart-Lock ‘Setup and Use’ documentation to proceed or visit 

okidokeys.com
Note : If you're already using an OKIDOKEYS Smart-Lock, you will need to do full reset before adding a new Smart-Reader:

On the web portal (portal.okidokeys.com) :

 

• Find the «Edit the Smart-Lock» page by clicking on your door name on the dashboard. 

 

• Go to the Advanced section and click on the «Reset the Smart-Lock» button

On your Smart-Lock :

 

• Remove the cover

 

• Use the provided screw-driver and press the Reset button (under the left top hole) for 10 seconds

The OKIDOKEYS Smart-Reader allows you to lock and unlock your 

Smart-Lock using both cell-phones and smartphones without BLE 

(Bluetooth 4.0). When used, these phones will emit an audible tone 

that the Smart-Reader can use to unlock the Smart-Lock.  

The Smart-Reader is also able to read OKIDOKEYS Smart-Tags to lock 

and unlock the Smart-Lock.
Your OKIDOKEYS Smart-Reader also includes a wireless bell using the 

Smart-Lock speaker to warn you when someone is at the door.

1

2

Remove the back from the  

Smart-Reader.

Take a picture or write down 

the 17-character serial number 

on the sticker in the battery 

compartment. This will be used 

to register your Smart-Reader 

online.

Install the three AAA batteries.

3

4

Insert and tighten the T-10 (Torx) 

screw from the bottom of the 

Smart-Reader cover.

Select a place near you door, not 

to exceed 10 ft from your 

Smart-Lock. Clean the area with a 

dry cloth.

Remove the film from the adhesive 

on the back of the Smart-Reader.

Press the Smart-Reader firmly to the 

surface you have selected.

5

The installation process is 

complete.

You are now ready to register 

your Smart-Reader online.

The batteries in your Smart-Reader can 

be replaced by simply removing the T-10 

screw and lifting the front of the 

Smart-Reader off.

Change the batteries and replace the 

Smart-Reader and T-10 screw. 

 Your Smart-Reader 

includes a safety alarm to avoid external 

damages. 

You will need to unlock your Smart-Lock 

prior to opening the Smart-Reader to 

avoid triggering the alarm. If the alarm is 

triggered, use an authorized Smart-Key 

to stop the alarm.

1 

(x3)  AAA Batteries

2 

(x1)  Smart-Reader

3 

(x1)  T-10 (Torx) Screw

4 

(x1)  T-10 (Torx) Screwdriver

5 (

Varies

)  Card

6 (

Varies

)  Wristband

7 (

Varies

)  Keychain

1

2

5

7

6

4

3

C

M

Y

CM

MY

CY

CMY

K

Smart-Reader Installation Guide V5.pdf   1   8/28/2014   12:04:26 PM