Wuxi MitraStar Technology Co. Ltd DSL100HNUT1V3 User Manual

Chapter 1    Introduction

12

2 Within two minutes, press the WPS button on a WPS-enabled client within range of the Device. The 

WPS/WLAN LED should flash while the Device sets up a WPS connection with the client. 

3 The WPS/WLAN LED shines green for a successful connection.

If you forget your password or cannot access the web configurator, use the RESET button at the 

back of the device to reload the factory-default configuration file. This means that you will lose all 

configurations that you had previously and the user name and password will be reset to the default.

With the POWER LED on steady, press the RESET button for ten seconds or until the POWER LED 

begins to blink and then release it. When the POWER LED begins to blink, the defaults have been 

restored and the device restarts.

The following graphic displays the labels of the LEDs.

Figure 3 LEDs