Touchtown Inc. TT3003 User Manual
Wireless Ecosystem
Version 0.3, March 2014
Pendant User Guide
Transceiver User Guide
The system locates a fall pad alert
Reset the alert
Transfer a patient
Call for help
Where can I use the Transceiver?
Transceivers are connected to bed, chair and floor alert pads. When there is a change
in pressure status, the transceiver sends an alert to the system. A red LED blinks to
indicate that a call was successfully sent.
The nearest locator description will be displayed for the mobile chair pad both on the
CMU and a pager. It may take up to 12 seconds for the system to calculate the closest
locator. The bed and floor pad report their assigned room designated during pairing.
CMU and a pager. It may take up to 12 seconds for the system to calculate the closest
locator. The bed and floor pad report their assigned room designated during pairing.
Push and hold the “Reset” button for 6 seconds. This will reset the alert if there is an
active alert and both red LED lights will blink 3 times.
active alert and both red LED lights will blink 3 times.
Push and hold the “Reset” button for 6 seconds. If there is not an active alert, this will
start a 60 second device time-out to transfer a patient without initiating a call.
The alert pads will work in the Alert Coverage Area set up during the system
installation. The alert pads will NOT work if you leave the campus. For safe operation,
this device shall be installed so that it maintains a minimum of 20cm between it and
any users
start a 60 second device time-out to transfer a patient without initiating a call.
The alert pads will work in the Alert Coverage Area set up during the system
installation. The alert pads will NOT work if you leave the campus. For safe operation,
this device shall be installed so that it maintains a minimum of 20cm between it and
any users
Status
Lights
Lights
Reset
button
button
Cable to
Alert Pads
Alert Pads