INS Global Pty Ltd S1-P User Manual

The reader has passed all relevant tests and obtained CE approval.

The reader has passed all relevant requirements for application of C Tick.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) 

this device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC  Rules. These limits are designed to 

provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if 

not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference 

will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the 

equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna

- Increase the separation between the equipment and receiver

- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected

- Consult the dealer or an experienced radio/TV technician for help

Any changes or modifications to this product not expressly approved in this document could void the user's authority to operate this equipment.

Designed & Manufactured in Australia. Mifare 

®

is a registered trademark of Philips Electronics.

Wiegand

+12Vdc

 

 

90% max, operating  non-condensing

67 x 50 x 16mm

Green/Red controlled by access controller

Charcoal

100m max

250m max

30 - 50mm

Connect the wiring as indicated in the table

 to the control panel. 
      Connect the 0V reference and 0V (if 

provided in the power supply) to the ground 

(GND) Wire.
      Connect the W0, W1, LED and Buzzer 
      Connect the +Vdc last.

Handle the reader with care. Do not drop or

damage before installation.

      If necessary, drill holes for the mounting screws in the wall on which

 the reader will be placed.

 

Alternately a back box can be used.

      Note magnet location for position of tamper reed switch (refer overleaf).

      Place the reader on the wall or back box, make sure wires are not crushed.

      Insert and hand tighten the screws.

      Check that the reader is level before tightening screws.

      Power up reader

If the reader doesn’t respond when a valid smart card is presented, 

check the following:

LED is not lit
LED is orange/indeterminate

or buzzer sounds low
Reader doesn’t respond

No power to the reader
Voltage to the reader is below 

minimum required level
Invalid card or card is faulty or

wiring to the controller is faulty

Check power supply to the reader

Check power supply to the reader

Check reader with another valid smart 

card; if problem persists check wiring

Mount the reader on a single gang box or suitable surface.

Make sure the wire bundle to the reader has an IP rating of at least IP65.

red

black

yellow

orange

green

white

+5 to +12Vdc 
ground
buzzer
green led
W0
W1

Each reader comes with a 3 year warranty from the date of 

dispatch. The warranty is void if the instructions contained 

within this document have not been adhered to.

Suite 8

166a The Entrance Road

Erina NSW 2250

www.insglobal.com

INS - IG - B1 - R01