Unique Broadband Systems Ltd. DRU1KW User Manual

 

 

During the commissioning (initial turn-on) procedure, the operator will be required to 
perform the following tasks: 

 

1.  Power-on the repeater 
2.  Configure the repeater 
3.  Place the repeater in broadcast mode 

 
 
4.4.1  Repeater AC/DC Power-on 

 
The repeater is divided into separate LB and HB cabinets.  However, there are several 

components (assemblies) which are shared by both cabinets, but are physically located in 
only one of the cabinets.  In this case, it is recommended that the HB sub-system is turned on 

before the LB sub-system is turned on. 
 

 
4.4.1.1 

 

The repeater AC/DC power should be turned on in the following sequence: 

 

1.  Switch ON the repeater circuit breaker, located in the building/site electrical service 

panel. 

2.  Switch ON the AC disconnect device, located on or near the repeater pedestal (where 

applicable). 

 
 
 

 
 

 
 

 
 

 
 
 

 
 

 
 

 
 

 
 
 

 
 

 

SX03-20000-01-M01 4-2