Unique Broadband Systems Ltd. DRU1KW User Manual

 

4.4.2  Repeater Configuration 
 

Repeater configuration involves verifying, changing, and/or setting parameter values that 
allow the repeater to operate from its assigned location.  The operator will be required to 

configure the following: 
 

  Low Band Exciter (LBE) 
  High Band Exciter (HBE) 
  Terrestrial Repeater Monitoring System (TRMS) 

 
 

 

Please refer to SiriusXM instructions as well as the LBE Operating Manual to configure the 

exciter with specific settings for its assigned location. 

 
 

 
Please refer to SiriusXM instructions as well as the HBE Operating Manual to configure the 

exciter with specific settings for its assigned location. 
 

 
4.4.2.3 

 
Please refer to SiriusXM instructions as well as the TRMS Operating Manual to configure the 

TRMS with specific settings for its assigned location. 
 
 

4.4.3  Placing a Combined DRU in Broadcast Mode 
 

As the repeater is divided into LB and HB sub-systems, each sub-system must be placed in 

broadcast mode, independent of the other.  It is recommended that the LB sub-system is 

placed in broadcast mode before the HB sub-system is placed in broadcast mode. 
 

 
4.4.3.1 

 

Once the LBE is powered up and all LBE alarms have cleared, the operator can place the LB 

sub-system in broadcast mode using the LBE GUI as follows: 

 

1.  Set SysPowerSetp to the site specific power level (max. 60.0 dBm) – see Figure 4-1, 

config window line 3.  SysPowerSetp is used to set the power level for the LB Main RF 
signal. 

2.  Set SysLbdPowerSetp to the site specific power level (typical value is 27 dB below 

SysPowerSetp) – see Figure 4-1, config window line 6.  SysLbdPowerSetp is used to 
set the power level for the LB Diversity RF signal, which is normally 27 dB below the 

LB Main RF signal. 

3.  Ensure that SysOfnLoss is set to 0.0 dBm – see Figure 4-1, config window line 4. 

SX03-20000-01-M01 4-5