Unique Broadband Systems Ltd. DRU2KW User Manual
Page 25
X75 SERIES - Mk3 Controller
INSTALLATION & OPERATING MANUAL
Manual No. x75mk3-11
x75-man-Rev11-0815.indd
The default network settings that the controller is shipped with are:
IP Address
– 192.168.000.200
Subnet Mask – 255.255.255.000
Gateway
– 000.000.000.000
All pages served by the controller’s built-in WEB server consist of two frames; a ‘navigation’
frame on the left hand side and an ‘information/programming’ frame which occupies the
majority of the browser window.
The menu items in the ‘navigation’ frame can be used at all times to jump between the
various pages. Clicking on the UNIPOWER logo at the top will navigate directly to the
Each of the blocks of information in the ‘information/programming’ frame is a Java applet.
In some cases these applets simply collect information from the controller and presents it
on-screen, in other cases the applets contain data entry fields for uploading programming
information to the unit.
Note that a PC screen resolution of 1024 x 768 or higher is recommended to avoid excessive
amounts of page scrolling.
The following sections describe the various WEB pages that can be viewed with the browser
and give details of programming parameters that may be entered and sent to the unit.
IMPORTANT NOTE: The screen shots shown throughout this section are ‘typical’ examples.
The exact data content will differ dependent on the system voltage and whether alterations from
the default settings have been made. Settings can be returned to the factory defaults at any time
by clicking on the ‘DEFAULT’ then ‘UPLOAD’ buttons on the relevant setup page. This action
requires the level 1 pass code.
The factory default passwords are:
User - 1234
Admin - 9876