OBSERVA Telecom RTSA04NU User Manual
BHS-RTA S User´s Manual
E
E
d
d
i
i
t
t
i
i
o
o
n
n
E
E
d
d
1
1
.
.
0
0
Page 27 of 52
4.4.5 PIN CONFIGURATION
Click Pin Configuration to enable the 3G PIN code as shown in the following figure.
Label “Estado” will
inform you about dongle status, if PIN is needed or not, or if modem has been detected.
4.4.6 3G DRIVER
By default there is a list of dongles supported by HomeStation, but there will be some of them, that could
be not supported. For this, Observa CPE allows to load new drivers in order to support new 3G dongles. If
there is a restore to default settings, these loaded drivers will be removed.
Load new driver and reboot CPE in order to make effective the change. Also you can clean flash memory of
these drivers by clicking on ‘Limpiar’ button.
be not supported. For this, Observa CPE allows to load new drivers in order to support new 3G dongles. If
there is a restore to default settings, these loaded drivers will be removed.
Load new driver and reboot CPE in order to make effective the change. Also you can clean flash memory of
these drivers by clicking on ‘Limpiar’ button.
4.4.7 ETH/GRE
Use this section for configuring the settings of transparent Ethernet over GRE Tunnel: