AMS DIFFUSION CB710 User Manual

Page of 17
EN-13
Disc
Disc is inside but no sound. 
 
Disc is upside down. 
Place disc in the correct direction, and the 
label side up. 
Disc is dirty or damaged. 
Clean disc or change another disc.
Disc sound skips, tone quality is low.
Disc is dirty or damaged. 
Clean CD or change another CD.
 
Sound skips due to vibration.
Mounting angle is over 30
o
Adjust mounting angle to less than 30
o
.
Unstable mounting. 
Mount the unit securely with the mounting parts.
General
No power or no sound.
Car's engine switch is not on. 
Turn your car's key to ACC or ON. 
Cable is not correctly connected. 
Check connection. 
Fuse is burnt. 
Replace fuse.  
Check volume or mute on / off.  
If the above solutions cannot help. 
Press the RESET button.
Radio
Noise in broadcasts.
Station is too far, or signals are too weak.
Select other stations of higher signal level. 
Preset station lost.
Battery cable is not correctly connected. 
Connect the battery cable to the terminal 
that is always live.
Troubleshooting
If  you  suspect  something  is  wrong,  immediately
switch power off. Do not use the unit in abnormal 
condition, for example without sound, or with smoke
or  foul  smell,  can  cause  fire  or  electric  shock.
Immediately stop using it and call the store where 
you purchased it. Never try to repair the unit yourself 
because it is dangerous to do so.
Please Recycle Your Spent Batteries
Batteries should not be disposed of in unsorted 
municipal waste, but separately collected to facilitate
the correct treatment and recycling of the substances 
they contain. The recycling of batteries ensures the 
recovery of these valuable materials and prevents any 
potentially harmful effects upon both the environment 
and human health.
Please contribute to battery recycling by segregating 
all spent batteries and actively participating in their 
collection and recycling. Various battery collection 
schemes will be in operation in different areas of 
the country. However, battery collection bins will be
available at retail stores that sell batteries as well as 
at schools, libraries and other public buildings.
Installing the panel
•   Hold the panel and ensure the panel faces
dwonward,  and  at  an  angle  set  one  side
of the panel in the panel bracket.Press the 
other side of the panel until it locks.
Anti-Theft System
Removing the unit
•   Remove the panel and the trim plate.
•   Insert both T-Keys into holes on the front of
the set until they lock.
•   Pull out the unit.
•   Turn the panel from horizontal to vertical,
push until it locks.
1
1
2
2
1
1
2
2
1
1
2
2
9482CMB747NA338A说明书-1-EN.indd   13
2014-10-28   13:44:38