Bernecker&Rainer Industrie-Elektronik Ges.m.b.H 5E903029 User Manual
Standards and certifications
Data sheet V 1.00 5E9030.29
27
USA:
Federal Communi-
cations Commission
(FCC)
This device complies with Part 15 of the FCC Rules and with Industry Canada li-
censeexempt RSS standard(s). Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Canada:
Industry Canada (IC)
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux ap-
pareils radio exempts de licence. L'exploitation est autorisée aux deux conditions
suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'ap-
pareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est sus-
ceptible d'en compromettre le fonctionnement.
If products are also equipped with an RFID read/write unit, it must be approved for operation in the USA and
Canada. These types of products are identified by a sticker with "Contains FCC ID:" and "Contains IC ID:" on the
RFID read/write unit. In addition to the additional sticker for products with an RFID read/write unit, the requirements
below also apply.
Information:
Changes or modifications not expressly approved by the party responsible for compliance could void
the user’s authority to operate the equipment.
Information:
This equipment has been tested and found to comply with the limits for a Class B digital device, pur-
suant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or television re-
ception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
•
Consult the dealer or an experienced radio/ TV technician for help.