Sun Cupid Technology Ltd. N5001L User Manual

purchase a memory card and install it into your device.

1. Make sure that your device is turned off, and then remove the back cover.

2. Locate the memory card slot on the upper part of the exposed right panel.

3. Insert the memory card into the slot with its gold contacts facing down until it

clicks into place.

Note: To remove the memory card, press it to eject it from the slot.

1.3 Charging the Battery

Your device comes with a rechargeable Lithium-ion battery and is designed to

use only manufacturer-specified original batteries and accessories. Battery

performance depends on many factors, including network configuration, signal

strength, and usage patterns.

Warning: To reduce risk of fire or burns:

• Do not attempt to open, disassemble, or service the battery pack.

• Do not crush, puncture, short external contacts, or dispose of in fire or water.

• Do not expose to temperatures above 60°C (140°F).

• Replace only with the battery pack designated for this product.

• Recycle or dispose of used battery as stipulated by local regulations.

New batteries are shipped partially charged. Before you start using your device,

it is recommended that you install and charge the battery. Some batteries

perform best after several full charge/discharge cycles.

Note: Only the AC adapter and USB sync cable provided with your device must

be used to charge the device.

Connect the USB connector of the AC adapter to the sync connector on your

device, and then plug in the AC adapter to an electrical outlet to start charging

the battery.

As the battery is being charged while the device is on, a charging icon appears

in the title bar of the Home screen. After the battery has been fully charged, a

full battery icon appears in the title bar of the Home screen.

Warning: • Do not remove the battery from the device while you are charging it

using the AC or car adapter.

• As a safety precaution, the battery stops charging before it overheats.