Ulterius Technologies LLC FDN40 User Manual
CHAPTER 15: OSPF
`FDN40ConfigUM/20160505
298
© Ulterius Technologies, LLC 2016. Confidential & Proprietary.
- Configure the OSPF router-id.
UltOs(config-router)# router-id 10.10.2.1
- Exit from the router configuration mode.
UltOs(config-router)# exit
- Enter the Interface Configuration Mode for VLAN 11.
UltOs(config)# interface vlan 11
- Enable OSPF over the VLAN interface.
UltOs(config-if)# network 10.4.0.1 area 0.0.0.0
- Configure the VLAN 11 interface as passive interface.
UltOs(config-if)# passive-interface vlan 11
2. View the configuration details by executing the following show command.
UltOs# show ip ospf interface vlan 11.
vlan11 is line protocol is up
Internet Address 10.4.0.1, Mask 255.255.0.0, Area 0.0.0.0
AS 1, Router ID 10.10.2.1, Network Type BROADCAST, Cost 1
Transmit Delay is 1 sec, State 2, Priority 1
No designated router on this network
No backup designated router on this network
Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit
5
5
No Hellos (Passive interface)
Neighbor Count is 0, Adjacent neighbor count is 0
15.5.12.2 WEB Configuration
O
SPF Message Digest Authentication can be configured through WEB
interface using the OSPF Interface screen. For screenshot, refer
section 4.5.3.2
section 4.5.3.2
Restore routing updates on interface VLAN 11. UltOs(config-if)# no passive-
interface vlan 11
15.5.13 Configuring OSPF Area Parameters
Area parameters can be configured only after enabling the OSPF process.
Area parameters are configured in the Router Configuration mode.
15.5.13.1 Configuring Stub Area
Configuring Stub Area specifies an area as a stub area. It also configures
other parameters related to that area.
other parameters related to that area.