ZHEJIANG LONGSUNNY INDUSTRY CO. LTD 42516 User Manual

Page of 3
CANDLETUNES™ instructions 
CHARGE THE CANDLE
1. Make sure the Candletunes™ power switch in the ( 
Ο ) position.
2. Connect the USB plug to Candletunes™.
3. Connect the USB plug to the adaptor plug provided then connect it to an electrical outlet. 
4. If an electrical outlet is unavailable, connect the device with a USB port.
5. Connect Candletunes™ to a power source to start the charge cycle and the indicator light will be red while charging.
    When the candle is fully charged the red light will turn off.
6. Disconnect the USB plug from the candle for use. 
Music & Light
ON
Candle
Off
Candle Light
ON
USB Plug
Connect
CANDLE USE
1. Candletunes™ can be paired with any device with bluetooth wireless technology.
    To start, put your device in “pairing” mode to connect it to Candletunes™.
2. Slide the Candletunes™ power switch to (     ) position. The yellow candle light will turn on and a blue light will blink near the Candletunes™ port.
3. Use your device to “find” Candletunes™ candle.
4. Candletunes™ will “beep” when successfully paired.
5. Play music on your device. Candletunes™ volume is controlled by your device. The blue light will flicker to show the candle is playing music.
6. The maximum working range between your candle and the device is 5 meters (16.4 feet).
7. Slide power switch to ( 
| ) position for candle light only.
CARE
1. Keep away from water or damp locations.
2. Turn off when not in use to save battery life.
• This device has an internal, non-removable, rechargeable battery. Do not attempt to remove the battery, as you may damage the device.
• DO NOT expose this device to fire or water.
• Use of incompatible chargers may present a risk of fire, explosion, or other hazard that can cause battery to overheat, rupture, leak, or explode,
   resulting in personal injury and/or property damage.
• Dispose of this device in accordance with the laws and regulations in your area governing disposal of rechargeable battery cell types.
• Never use this device or its charger if it is damaged.
• Never touch damaged or leaking batteries - this could result in burn injuries or cause serious internal injuries if swallowed.
  Obtain medical attention immediately if this occurs.
• Only use the charger indoors.
• Use this device and charger for their intended purposes only.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1) This device may not cause harmful interference and 2) this device must accept any interference received, including interference that may cause undesired operation.
Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to 
provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and if not 
installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur 
in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the 
user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Shielded cables must be used with this unit to ensure compliance with the Class B FCC limits.
This device complies with Industry Canada license - exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, 
and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Under Industry Canada regulations, this radio 
transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference 
to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful 
communication.
Adaptor
Plug
CANDLETUNES™
PC
CANDLETUNES™
bottom view
USB
Plug
KEEP THIS INSTRUCTION SHEET FOR REFERENCE AS IT CONTAINS
IMPORTANT INFORMATION.